Hi, yes it should work.🙂

It is necessary to program them in for proper functionality.Your check engine light is on because you have stored some fault code in your ecu.

Autocom videos will be in the future🙂

The procedure is indicated by diagnostics :)

yes, the software is compatible with obd2. On the page you can find out if the diagnostics is compatible with the car.

@@easywork2 i have a noname obd2 for Chevrolet Orlando and i want to coding the injector because i changed all four, i also can use Delphi diagnostic Software on my Laptop and connecting with Bluetooth to my noname obd2?

@@HiiBo23 yes, it can also be connected via cable

Unfortunately, the production of identical nozzles is not possible even in a first-class production facility. Because common rail injectors operate at very high pressures, small differences between them can make a difference in the amount of fuel they deliver. This is about the efficiency of the engine, which can be a reduction in its power and an increase in noise and smoke. The amount of fuel supplied by the injector is proportional to the injection time (impulse) and the pressure in the rail. Therefore, it is possible to compensate for the performance difference by controlling the pulse duration for a given injector. New or refurbished injector, it must be marked with a specific code. Installing an injector on a vehicle with this code requires reprogramming the engine control system (ECU)

Hello, write the time when you think. Thanks for the comment :)

Hey, yes it will work on accord too.

I also changed the timing chain to N22. Watch the video on the channels.

Do you have a clone tool or original? My brother has clone, but it's dual board same as yours case.

@@StefaTGMI can't write here. But the original is expensive 😅

@@StefaTGMI am preparing more videos with this diagnosis. It has many functions. Subscribe to the channel, many things will be connected with the diesel Honda.

Did you look at an authorized dealer?

​@@easywork2Where can i find authorized dealers and do they charge the software in a subscription model?

yes it will work

Injector overhaul?

If you don't replace the electrical part of the injector, you don't have to code it.

Yes, you can also code a freelander. You have to follow the instructions in the video.

@@easywork2 they say that it cannot code injector on every car. that's why I asked you

@@Pera-Peric what engine do you have?

@@easywork2 land rover freelander td4 2004 bmw engine 204d3

@@Pera-Peric it will work 🙂

Injector correction can be viewed in delphi. Want a video?

@@easywork2 yes

I don't understand Italian