I purchased a series of steam radiators that I needed to convert to hotwater. here I show how to install a bleeder device.
Пікірлер: 17
@walterbrunswick2 жыл бұрын
ahh yes, and then the vice grips..... I guess I should have expected that next
@walterbrunswick2 жыл бұрын
Having done machining in trades college, the drilling and tapping done here was hard to watch Also currently being an HVAC tech, no more than 2 layers on 27 TPI..... 3 4 layers AND pipe dope.... wtf smh
@kensheets51892 жыл бұрын
Thanks for the input, I'm sure you love critiquing amateurs on KZfaq because u couldn't do that to an actual peer as they would tear you up. All ten radiators worked perfectly, no drips even with excess tape, pipe dope and vise grips, who knew.
@jeffreyjohn20378 ай бұрын
@@kensheets5189you're an absolute hacker.
@kensheets51897 ай бұрын
@@jeffreyjohn2037 thanks!
@Shelby-mh3cf2 жыл бұрын
Nice video, detailed instructions for the DIY. Thumbs up
@FrustratedBaboon6 ай бұрын
These radiators only have a single steam line feed and no return. How did you convert or install the water return? I didn't see that in this video. Thanks.
@migdaliadiaz88302 жыл бұрын
you tap that radiator wrong ,bleeder goes to the o positive side of the radiator valve
@cubacereos6851 Жыл бұрын
I'm about to convert steam radiator to hot water. what is the benefit for installing the bleeder on opposite side?
@kensheets5189 Жыл бұрын
Yep, I'm not a pro so I wasn't aware that it made a difference what side it was on, but it worked non the less. System seemed to operate well.
@empanada7 Жыл бұрын
is this works the same with a two pipe steam too
@garnermorgan7785 Жыл бұрын
Looked to me he covered the bleeder with thread tape.
@kensheets5189 Жыл бұрын
I noticed that in the video as well, it worked non the less but I would definitely pay more attention to that issue.
@sharonsmith15059 ай бұрын
why drill that plug could be sized down to inch a quarter by one eighth,, blk bushing,
@jeffreyjohn20378 ай бұрын
You're about as dumb as the clown making the video.
@kensheets51897 ай бұрын
I dont know what that means but if I did I probably would have been all over it.
@missqlalah9 ай бұрын
You could have just removed the plug and changed it to a reducer bushing by one eighth by inch and a half