How To: Fit A Tow-bar To A Ford Mondeo Mk3 (2006 Model)

No video

How To: Fit A Tow-bar To A Ford Mondeo Mk3 (2006 Model)

Рет қаралды 22,580

Күн бұрын

This is how you fit a tow-bar to a Ford Mondeo 2006 hatchback.
Kit used: TF171 from Towbars-uk.
Wiring Details:
Pin1 Yellow(LH Signal) to Blue on car.
Pin2 Blue(Fog) to Green w/Yellow tracer on car.
Pin3 White(Earth) to suitable Earth point.
Pin4 Green(RH Signal) to Blue w/Red tracer on car.
Pin5 Brown(RH Tail) to Orange on car.
Pin6 Red(Stop Light) to Green w/Red tracer on car.
Pin7 Black(LH Tail) to Orange w/White trace on car.

Пікірлер: 23

@helgedell 3 ай бұрын

Very helpful. Thanks a lot!

@tonyg5681 4 жыл бұрын

Thankq, that was I great help, 1 problem when I came 2 the wiring, brown 2 orange I connected 2 the wrong wire as there r 2 , it's the thin 1 ,all sorted now , thanks 4 your help , much appreciated

@leehallett6097 7 жыл бұрын

Nice video mate, very informative

@ionutfg 5 жыл бұрын

Thank you for this vid mate. I just found an towbar on an mondeo mk3 and i put on mine now.

@anthonyporritt948 6 жыл бұрын

I fitted my tow bar using this video(I problem to over come is the nuts that hold the bumper/heat shield, you need a special tool-or do like I did and use a socket with a drilled hole in it a put a screw in it)but a good video to watch and do

@keytesofessex 5 жыл бұрын

Thank you, saved me time

@martinburbridge7545 5 жыл бұрын

just used this to mount my towbar all on now run out of time just got to cut bumper and run electrics but found it useful as the instructions wasnt working on my own so car was on ramps i used jack to raise bar up to bolt it through rear bulk head

@mapex1976 5 жыл бұрын

Cheers man,very good informative vid👍

@kevwilliam 3 жыл бұрын

Did you not need to put any relays or anything in between the trailer wires and car loom? Thanks for the video I'm just about to do mine on my mondeo too

@StraightCutMotorcycles2018 3 жыл бұрын

Not on mine as it had standard bulbs fitted for the lights.

@kevwilliam 3 жыл бұрын

Nice one mines on standard bulbs too so happy days 🤞 thanks for your reply

@twistyturd 5 жыл бұрын

Great video, just to confirm this car doesn't have cunbus wiring for the lights and you can just connect straight up?

@Mike--K 7 жыл бұрын

Nice video! Did you have to drill the holes in the chassis to mount the two angle bars or were they already there?

@Mike--K 7 жыл бұрын

Thanks!!!

@farley1992 4 жыл бұрын

There are already there

@milmorguy 5 жыл бұрын

Hi Peter, what was the cable that you didn't connect up? Is it needed? Cheers, Mike

@neilm2701 7 жыл бұрын

One question about the electrics, can I ask why you didn't fit either a separate indicator warning light in the front, or an indicator buzzer box to the car, for when a trailer/caravan electrics are plugged in, as it is a legal requirement

@welshboyo1042 5 ай бұрын

Not on older cars its not

@owner3105 7 жыл бұрын

Got a problem! I've got it all wired up but seem I have constant power or something. Side lights are constantly working on trailer unit when engine is off and have to unplug. Why? Is it 12v power, ground not correct?

@swedishkev 5 жыл бұрын

High mate , just have a question, Do you only need to wire all the wires on one side of the car and does it matter what side ?

@swedishkev 5 жыл бұрын

@@StraightCutMotorcycles2018 Ok, thanks does that mean you need to take an extra cable over to the side. I have a citroen Picasso 05 and l am finding out it is multiplex, so might need a relay or a plug n play kit. All getting complicated.

@owner3105 7 жыл бұрын

I have a problem? I've connected mine all up although seem to have perm live going to trailer lights so lights are always on and have to disconnect the trailer plug to prevent battery drainage.

@owner3105 7 жыл бұрын

I've connected to a 54 Plate Ford Mondeo. I've done this the same way as in video, although the plug was pre attached to Towbar when I bought it so unless incorrectly wired to plug but everything else work fine expect lights are always on when the car is off which is wrong