Some quick notes on how to fit manual hubs on your Jimny.
Пікірлер: 25
@steveirving24493 жыл бұрын
Just about to order a set for mine after a failure of the vacuum system, heard it was a simple swap and now I've seen it, it is a simple swap! Thanks for posting the vid!
@gerryward72 жыл бұрын
Can you show me more photos of the last part of the wiring bringing, is this for all models mine isn’t electric button select 4wd.
@CLSJimny4x42 жыл бұрын
Hi, don't have any more pics I can find. I think it needs to be done for the manual lever 4x4 as well as it sorts the dash light. Cheers
@abdulra7man.9973 жыл бұрын
Why disconnected the vacuum bibe??
@CLSJimny4x43 жыл бұрын
Did mine upon recommendation. I think it is a personal choice. Cheers
@m13ajimny25 Жыл бұрын
Jimny how many splines?
@CLSJimny4x4 Жыл бұрын
Hi, can't remember to be honest. Should be easy enough for you to work out what you need on Google. Cheers
@Off-roader-2 жыл бұрын
Bridging the connector hasn't done anything on mine to stop the light flashing any suggestions?
@CLSJimny4x42 жыл бұрын
Hi, make sure the connection is good as I found it a pain to get right. It is the top part of the connector that needs bridging. Have you blocked the vac lines? Not sure if they have any bearing on the light. Cheers
@Off-roader-2 жыл бұрын
@@CLSJimny4x4 hi buddy yer all vac lines are blocked up and the pipe on the inlet manafold is blocked too i literally just cut the connector block off and twisted the wires together was to tight to brige it with the connector on still haha got hands the size of a shovel 😂
@CLSJimny4x42 жыл бұрын
@@Off-roader- that's my idea shot then! Try bigjimny.com they have some people in the know. Cheers
@Off-roader-2 жыл бұрын
@@CLSJimny4x4 already tried the bigJimny forum mate 🤣 KZfaq was my last hope 🤣 😭🤣
@benruddock3742 жыл бұрын
Mine was the same. I think the later 4x4 controllers must have on and off feedback from the pressure sensor that gets bridged. I could get it to engage the front prop but because the 4wd light was flashing it wouldn’t let me select 4low.