The good: spark plug removal, spraying lube in cylinders. Your patience. Your good luck in getting it running. The bad: This is a text book way to burn out a starter. Between 1:40 and 2:17 you rotated the crank but the water pump pulley did not rotate. This proves either the water pump pulley (top center) or power steering (?) top right were seized. It is always best to remove the accessory belts, free up the cylinders and valves first, then reintroduce 1 belt at a time to minimize the load on the starter or breaker bar (crank bolt).

Thank you!!!’ I just bought a 1980 Tahiti Day Cruiser.. with the same engine and it sat for 6 years! I have no idea if it’s frozen but after this video I’m so ready to tackle it! Thank you!

My 7 year-old son and I enjoyed watching you guys get this started👏👏👏👍!

Nå początek wykręć świece wprowac do cylindrów środek na bazie oleju smarowania i rozpuszczania nagaru i rdzy. Potem delikatnie poruszać wałem specjalnym kluczem po zdjęciu koła napędowego paska. A sstepnie kręcisz rozrusznikiem po odklejeni pierścieni od cylindrów. Sprawdzasz iskre świeże paliwo i powinien zapalić. 💪👍🔥

Dobra robota panowie

Ok, I'm struggling with this same issue. Where did the dirty water come out from? The spark plug wells? I'm looking to possibly replicate this

The big issue with a seized boot engine is that there is a great chance the engine is cracked on the inside (freeze damage). If you're lucky then it's only a bad gasket from the intake manifold. Both can be repaired but the block being seized is probably not your only problem.

I can see that this was two years ago and everyone has to learn, but this was painful to watch...

I just bought a renken spitfire v8 and it wont start, the last owner had its sitting in a warehouse for 2 years. I have not yet found the courage to even touch it and I don't know what to do, mind giving some tips?

Only in absolute emergency. That hurt

No WD 40 Use graphite penetrating oil

Take plugs out bro. And spray insidethere after letting sitting ur fighting everything

What are you putting liquid wrench in the air intake ? Just asking I thought it goes in the cylinder

Hi great job getting it going. How long was the engine sitting to get sized like that? I have same issue I am sure

I hope mine does this did you soak the cylinder heads in anything?

Good way of burning out your starter

The bolt to my crank has been rounded and I cannot get a socket on it 🙃

Did you put that washer on crank bolt?

I have the same issue

Does this work with a mercruiser 3.0L

Better to remove the plugs put oil in the cylinders and rock the engine back-and-forth by hand with a socket wrench instead of trying to fry the starter

what motor is this cause i just bought a boat and i cant identify the motor yet, but this one seems to be very similar

Did you have water in engine? If so where do you think it came from

Dobra jest

Are you in Florida if so could you help me

I’m not even a mechanic and I know this is wrong. Get a big breaker bar and put it on the front and turn it over by hand.

Lol 😂

Dont want to sound too harsh, but you really have no idea what you're doing, and some of what you did was very dangerous.