How to Fix Ariston Clas One Error 1P4

No video

How to Fix Ariston Clas One Error 1P4

Рет қаралды 16,379

Күн бұрын

Fault code 1P4 or 108 indicates low water pressure within the system, which is a simple fix that all owners can perform themselves.
If you see on your Ariston Clas One the Error 1P4 this video is definitly for you. Actually the 1P4 or 108 error codes have the same meaning so this applies also for the error code 108.

Пікірлер: 30

@Dianamusceleanu 5 ай бұрын

You was so useful! Thank you so much

@BotondBereczki 5 ай бұрын

I'm happy that it helped.

@amanuelgetachew9388 2 ай бұрын

Thanks i fix my heater after looking this video

@klaratozser6779 3 ай бұрын

Köszönöm a segítséget

@BotondBereczki 3 ай бұрын

Örülök hogy segített.

@mlmgrn6337 9 ай бұрын

Mi e' stato utilissimo!!!

@BotondBereczki 9 ай бұрын

Happy to hear it.

@maniaprauk 3 ай бұрын

Need a urgent help. I installed the brand new Ariston One boiler but that is not working, showing overheating error 105. Can you reply me please for how to fix that error.

@BotondBereczki 3 ай бұрын

maybe this helps. I believe you have a jumping started added to the heater. you might have to add a termostat. kzfaq.info/get/bejne/pqieiax8mbnFYKc.html

@nowbish Ай бұрын

Thank you! I solved mine also. But fo you know why this happens?

@BotondBereczki Ай бұрын

I'm happy it helped. Probably your system where close to the low limit threshold. Could be do to time or some small water drops. If it will loose pressure in short time it is recommended to verify your system to prevent any water damage. Otherwise it is normal a minimal pressure loss over the years.

@edimasov 10 ай бұрын

Hi! Can you please give me advice or help.. Got this boiler. Minumum temperature set to 35C, at home around 22-23C, but boiler starts up each 2-3 minutes for 10 seconds.Is it normal? If no, can you say what need to do? And maybe will be better to set minumum 20C? I read the instructions but don't understand clearly how to do it. I will be so thankful if you can help. Thanks!

@BotondBereczki 10 ай бұрын

Hi. It doesn't sounds like a normal behavior. Just one question, based on the Thermostat settings should the boiler start or not?

@edimasov 10 ай бұрын

@@BotondBereczki sadly, I don't have thermostat for now, and boiler used temperature from radiators

@BotondBereczki 10 ай бұрын

I believe a Thermostat could resolve then this issue. At least it is a try worth.

@edimasov 10 ай бұрын

@@BotondBereczki ok, thank you so much for your answer! Are you tried Cube S from Ariston? Does it good thermostat?

@BotondBereczki 10 ай бұрын

I'm actualy using Nest Thermostat 3 gen with the boiler. Let me know what will be the result.

@monicaungureanu783 8 ай бұрын

thank you sooo much!!! 😊

@BotondBereczki 8 ай бұрын

I'm happy it helped.

@krzysztofmrowczynski221 8 ай бұрын

Any ideas what to do when i turn the blue valve but nothing happens-the pressure stays the same.

@BotondBereczki 8 ай бұрын

The pump is not connected or the hidrofore/water system is not strong enought. You have to check the pressure on your water system.

@cristiturcu5662 5 ай бұрын

Thank you

@BotondBereczki 5 ай бұрын

No problem. I'm happy that it helped.

@alt8620 5 ай бұрын

Do i need to loosen the screw?

@BotondBereczki 5 ай бұрын

Depends how the water goes in to the boiler.

@alt8620 5 ай бұрын

@@BotondBereczki well i was asking because the thing wouldn't twist no matter what. But it got solved when someone with greater strenght came and helped. But the video was helpful

@BotondBereczki 5 ай бұрын

Happy to hear that.