Excellent service I have to try myself many thanks again
@TonaziTube Жыл бұрын
Thanks for watching!Dont forget to like,share and subscribe this KZfaq channel
@dingdong32013 ай бұрын
Thanks..bro..
@TonaziTube3 ай бұрын
You’re most 🤗 welcome
@angpeng_ukemsia79082 жыл бұрын
Thank you so much! I finally found what I want. 😊
@TonaziTube2 жыл бұрын
Welcome Sir ! Thanks for watching.
@otromen33 ай бұрын
Very helpful
@TonaziTube3 ай бұрын
Thanks for Watching
@pop_viral3 жыл бұрын
Good sharing!
@TonaziTube3 жыл бұрын
Thanks for watching
@8909lee2 ай бұрын
May I know what song is the back ground?? Nice..
@TonaziTube2 ай бұрын
Background song : Build a Bitch - Bella Poarch
@sindychan570 Жыл бұрын
Thank you so much :) for sharing the skill of it
@TonaziTube Жыл бұрын
Welcome!Thanks for watching
@nurinhusnina59503 жыл бұрын
Thank you Sir
@TonaziTube3 жыл бұрын
Welcome 🤗
@HONDAGAMING-sz4po2 жыл бұрын
Thank u
@TonaziTube2 жыл бұрын
Welcome! Thanks for watching.
@rogerfroud3009 ай бұрын
You ought to take the shaft out and replace the O-rings too, because they often leak. You'll also find that there's a bearing/spacer ring behind the flange on the shaft, and those can be broken or worn down to the point that replacing the other parts won't fix it anyway. In fact, those spacers have been the fault on two of my taps, and the repair didn't require the replacement of the discs at all. When you remove the shaft, you can press all of those parts out in one go, just by pushing on the end where the tap fits. You only have to remove the clip. Why do half a job?
@TonaziTube8 ай бұрын
Thanks for advise and problem sharing
@atatbrigsbrigoli70783 ай бұрын
✅
@TonaziTube3 ай бұрын
Thanks for watching 😍
@burpofhunger Жыл бұрын
I have trouble removing that fat ring thing. Any tips?
@TonaziTube Жыл бұрын
You may need Slip joint pliers.Refer link video kzfaq.info/get/bejne/rqhnm7eHnKyylYU.html
@PuffOfSmoke Жыл бұрын
I've replaced the sink faucet's ceramic washer but the faucet still drips. Any idea as to what's wrong with it?
@TonaziTube Жыл бұрын
Get wrong installation back or have issue with the tap valve.Try to reassemble
@PuffOfSmoke Жыл бұрын
@@TonaziTube actually we had a plumber put in a new faucet for the sink because the old one was dripping. After 3 months the newly installed faucet started dripping. I replaced the ceramic washer and it would stop dripping, but a week later it would drip again. So far, I've replaced about 4 washers for 3 months now. I've done some research and it says the valve seat could be the problem? Sorry, I'm just ignorant with this thing. That's why I'm reaching out. Just frustrated. Thanks for the reply. Appreciate it. 💯
@TonaziTube Жыл бұрын
Hope you can solve this issue soon.Difficult for me to advise without see the real thing happened.Just only try advise what I suspect and hopefully it can solve it.
@PuffOfSmoke Жыл бұрын
@@TonaziTube you've helped me a lot. Thanks again.
@s.k.sarkar5206 Жыл бұрын
How to open the Grohe bib tap ? There is no such screw on body
@TonaziTube Жыл бұрын
Hi Sir!Screw may have cover on it.normally at the top head or area of the tap.