Thank you, this means a lot.

Thank you for your feedback! Good job! If you liked my video I would much appreciate if you could support my channel.

Hi, I buy most parts from ebay.

Hi, It is on the video how to put on the drum and initially it’s visible how I started to put on the roller. It’s quite hard job, as it is really tight. You can use carefully a screwdriver to help and additionally slowly turn the drum and the belt will move to its place. ( if already partly on the roller)

Hi, Thank you for your question, in my opinion it isn’t the bearing. If the belt is ok, then you should check the capacitor. These are the 2 main reasons for drum don’t spin. I hope I could help.

@@georgesworkshop8600 will this work on ariston dryers

Hi, This is a common issue with tumble dryers, most of time this capacitor replacement sort the problem. I’ll make soon a video about this job.

@@georgesworkshop8600 Hi, I have the exact same tumble dryer and have already changed the belt once. I had a bit of trouble getting the new belt over the tension pulley. The original belt had snapped so bought the exact same one to replace it so thought it was a bit odd. It’s snapped again so have just ordered a second one 😫 just wondering if you have any tips on getting the belt over the tension pulley? Thanks - Rob

Hi Rob, I know what do you mean. I get used to dislocate the back axis and then the drum could drop down 1-2 cm. This is not too much, but enough to make easier the put the new belt in its place. And put the drum back ( axis return to the hole) The pulley could cut the belt if not on the right place. I hope I could help.