Glad I could help. Thx for watching.

Thx for watching Steve. Glad I could help!

Great Chip. I hope this helps.

Thx Andy. U could do this!

Thx for watching Roger. This thing has been awesome.

Thank you. I hope it helps.

Hey Prakash, thx for commenting. It’s funny because I kind of had a heater problem this year when we opened our pool. I wouldn’t get any error codes but it didn’t sound like the heater was kicking on full blast. U know what it sounds like when it’s burning. So I did some trouble shooting, replaces the igniter, it was the cheapest place to start. However, my pool was running. A day or so later, I noticed that the return jets to my pool weren’t very strong. So, I ran the heater until it said “Service” three I flipped the lid over and noticed that the “PS” LED was lit. Pressure Sensor”. Bottom line was, I needed a new pool pump. Replaced that and haven’t had any issues with the heater. The heater didn’t function properly because it wasn’t sensing enough pressure. Perhaps your pump is going?

@@jordanseverydaydiy4373 Thanks for your insight. I cleaned all filters and raise the pool water level as I think it was bit low. The heater and the pump both are running well for over 9 hours now. If it keeps running well, may be the low water level was the problem. Thanks again buddy.

Thx for watching Michael

Thx for watching Mr Jimmy. Man, u are asking something above my skill set. Do u have the owners manual? It sounds like most of the stuff u did would convert it, but there must be something else u haven’t done. Maybe a programming function?

Rm, I’m sorry I cannot. Im not familiar with that particular heater. Do you still have the owner’s manual? It might give you some troubleshooting tips or Google the issue, you might get an explanation or a resolution. Let me know.

Well, we m not a pool expert. But, to me I would look into the igniter . It sounds like that could be bad. It’s a really easy part to change, but u do have to remove the sides and top. After that, it’s 2 bolts. This senses temp and ignites the gas. Might be something to try. There is also on the underside of ur circuit panel, some small LED lights, when it shuts off, remove the top and see which one is lit. That will tell u if one of the sensors is bad. Pentair 77707-0054 Igniter and Gasket Replacement Kit Pool/Spa Heater Pentair 77707-0054 Igniter and Gasket Replacement Kit Pool/Spa Heater

Thx for watching. It really depends on a number of variables. Size of the pool, time the pump is running, ambient temp outside, number of skimmers, number of jets, pump size, pipe diameter, etc. you get the picture. We have a 35k gallon pool with 2 skimmers, a drain, and 4 inlet jets. If I let the pump run continuously, and say it’s 72 outside, it might take 18 hrs or so to get it to say 82. Also depends on the age and efficiency of the heater.

I’m sorry to hear that. We love ours, But, things can go wrong. When they don’t, they are incredibly enjoyable.

Tell me about it. I own two houses with pools. In the last 10 years I’ve spent a fortune just on pool heater replacements and repairs and now another needs to be replaced again. I hate it.