A very important point here which isn't addressed is to NOT mount the tube flush on the bow side (forward) but add a fairing which will reduce drag. It's also important to round over the edges of the tube to reduce noise when operating. You'll DEFINITELY hear the difference.

Truly a wonderful job!

What a great project!

Overall gets the point across Good job

Very nice. The concern I have is that motor sitting up there lije a small tower and beating through the waves with it just screwed down to a plastic tube. Over time the beating looks like it would beat it lose. I was think I g they might secure it more then with just the screws in the tube. Just my thoughts but a nice looking job

I need one of these...

I have the same makita tool I use when buffing boats, what pads do you use for grinding any recommendation where to buy a grinding pad and where that I can use on my makita ?

Looks awesome. I watched a different video where the owner was saying it times out after 5 minutes, that sounds wrong. I've seen bass fishing with the front motor going all day long, and you could switch to another marine battery if needed. How much juice does this motor use?

Great video...one question please if I may? Did you use Epoxy or polyester resin. Kind regards 😊

At the 2:20 mark. Isn't that cut stringer like really important to the structural integrity of the boat?

No demo?

How much does this cost? Thx

What brand fiberglass filler are you using in this video?

Nice👍. Beste Grüße aus Bayern. K.W.

Good video. Guys, get a few bozes of nitrile gloves, your hands will thank you.

That must destroy the integrate of the hull!

can a Bow Thruster be installed on 2004 Sea Ray 260 sundancer

I am working for a big thruster manufacturing company and the gasket at 3:45 should be place inside the tunnel and not outside like shown in the video.

it is not grey gel cout it is top cout

DIY? Misleading title.