How to install a garage door opener - XTrac (Centurion)

How to install a garage door opener - XTrac (Centurion) - detailed

Рет қаралды 32,765

5 жыл бұрын

PLEASE NOTE, THE SAFETY ASPECTS OF THIS UNIT DO NOT MEET THE SPECIFICATIONS THAT ARE STATED IN THE MANUAL!
How to install a garage door opener - XTrac - step by step
This is a detailed DIY, every step is shown so you may "do this yourself"
Centurion XTrac

Пікірлер: 33

@legrange 3 жыл бұрын

Mate! That fiddly stuff from around 51:30 is exactly what I needed. Nice one.

@alljoy6541 5 жыл бұрын

Thank you. I am going to install a switch, so your video is useful.

@andilemngadi1315 4 жыл бұрын

good job

@ghorak001 6 ай бұрын

my motor is only showing 5v to the battery. i bought new power supply for the motor. How do you replace the charge controller and power supply box ?

@tutiabinh9611 3 жыл бұрын

How can I put the safety centre in the same Moto

@lupimataboge1150 3 жыл бұрын

Great stuff. Thank you. I need to replace the battery on my xtrac but I do not know where is located. Please help

@behindthestory5834 Ай бұрын

On Top Beside The Motor (The Opener)

@vikashvallabh4475 Ай бұрын

@@behindthestory5834 thank you, how do we go about opening the compartment?

@tutiabinh9611 3 жыл бұрын

I have the exactly model like you how I put Centre

@KeasDad 7 ай бұрын

Remote controls?

@grahamdaly1314 3 жыл бұрын

My double door will not open🤨 thanks for the information sir.

@Glyonart Жыл бұрын

How do you replace battery

@juanduplooy495 3 жыл бұрын

How do you add a sonoff wifi switch

@tutiabinh9611 3 жыл бұрын

Can you show me the video putting the wire safety sensor on the same motor what you show

@ecologicaltime 3 жыл бұрын

kzfaq.info/get/bejne/qtmkgpx30aqxfI0.html

@gordonlotter 2 жыл бұрын

How do I activate the safety reverse? When the door hits something it stops and reverses automatically.

@ecologicaltime 2 жыл бұрын

it doesn't work

@sugennaidoo646 3 жыл бұрын

Hi, have you installed a Centurion SD04 garage door opener?

@ecologicaltime 3 жыл бұрын

@winniemakhwanya4969 3 жыл бұрын

@@ecologicaltime hi how do I manually open the garage with the xtrac - im stuck

@tutiabinh9611 3 жыл бұрын

I have the exactly model light you how I can put the safety sensor

@ecologicaltime 3 жыл бұрын

kzfaq.info/get/bejne/qtmkgpx30aqxfI0.html

@matsobanejohannes2002 Жыл бұрын

Plein at the back

@hardusvd 5 жыл бұрын

My door keep opening automatically when closing the door. What could be the problem?

@ecologicaltime 5 жыл бұрын

have you checked the following: 1. loosen the safety lever/unlock lever and then try open and close the door manually. if there is minimal resistance, then you have ascertained that the door is not stuck. 2. Check there is no obstruction on the downward cycle. 3. Are there safety beams? If yes, disable them and then check again. 4. Check the limit switch placement 5. Check the calibration cycles. I would manually perform the re calibration and see if it performs it.

@robertmultitv5639 5 жыл бұрын

Were are u plz

@plakkies007 4 жыл бұрын

Did not watch the entire hour video, but I could not see how to install a remote to the motor? If it is there, whereabout in the video will I find it? The rest was useful, thanks.