installation of roofing shingle ridge cap . peak of the roof. #Roof #roofing #shingles #shingleroof #shingling #house #project #work #Remodel #fixerupper #reconstruction #job #construction #newconstruction
Пікірлер: 19
@elijahemmons19995 ай бұрын
That is exactly what I needed to see so I can add that to my list of construction knowledge!
@NYAG5 ай бұрын
Good! Happy constructing!!!
@gregory42474 ай бұрын
Cut them square,fewer cuts no scrap and the square edge helps line them up.nice hitahtci gun.also pop a line,and also nail on the tar line.two nails per cap.
@gregsmith38735 ай бұрын
You didn't show the most important part, where the three runs come together.
@NYAG5 ай бұрын
You are right. I also didn't have the finishing cap. Next roof I do, I'll try to make sure and get that.
@clivehurdle22743 ай бұрын
Do you.need to.heat the tar strip so.they all get stuck down
@NYAG3 ай бұрын
Overtime it bonds together with the summer heat.
@snort4552 ай бұрын
Well done. thanks for
@NYAG2 ай бұрын
Thank you, For support, please subscribe if you haven't.
@larrycrookshanks16464 ай бұрын
You are cutting way to much off of each side of the caps. A 1/4" is more than enough. The reason that manufacturers make pre-made caps is so that there are 4 nails in each cap. And you don't cut the outside factory edge. The way your installing each cap is only getting 2 nails.
@NYAG4 ай бұрын
4 nails on each side!? Seams like more then needed... Good to know bout the ¼" as I was just eye balling cuts.
@larrycrookshanks16464 ай бұрын
@NYAG When you use 2 nails they catch the previous cap thus holding each cap with 4.
@themayorbnb5 ай бұрын
Had a roofer tell me it was "against code" to cut your own caps. Who's got a code reference for me???
@NYAG5 ай бұрын
Probably varies per state / county. Could be, but I wouldn't see why. so I honestly couldn't tell you.