How to make a mini table saw?
Hello
In this video, I will show you how to make a table saw.
I use PVC because it is strong, light and waterproof.
You can use appropriate milling plates depending on the material you want to cut.
You can also adjust the cutting depth.
And you can also use a stronger or weaker motor (depending on what you are cutting).
Its construction is simple and not complicated.
This saw can also make angled cuts.
The weight of this tool is about 1.5 kg.
If you like this style of videos, please like and subscribe.
/ @mrpvc-tb1lt
_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_
Necessary supplies:
775 DC motor
GT2-6 belt and pulley timing(16,40 teeth)
Shaft 8mm
Motor gerbox 50 rpm
bolt and nut
PVC pipe
Ball Bearing 608
8mm shank M10 arbor mandrel adaptor
cutting board
switch
Regulator 7805
100 nanofarad capacitor
Motor starter capacitor
heat sink
Micro switch
1n 4007 diode
6 pin key
Female and male connector
#Mr_PVC
#DIY
#PVC
#PVC_pipe
#How_to
#table_saw
#Mini_table_saw
_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_
00:00 Intro
00:27 Convert PVC pipe to PVC sheet
01:16 Cutting parts and sanding
03:28 Body construction
04:35 labeling or painting
05:04 Construction of motor base and shaft
09:54 Connection of motor parts and shaft
11:00 Schematic and wiring
12:26 Connecting the base on the body
14:17 Initial test
15:23 Construction of cutting rail
17:31 Tool test