The way she started the piece and having a unthreadable tread like that is never a good idea.. It's a shame she did this and teaching lazy bad habits. To have it with a tail at the beginning of the work helps with proper tension adjustments(,did you notice how hard it was for her to get the line through the tread bridges?) and means if you make a mistake or notice an off bead somewhere you can pull the needle off , pull back your work and correct, As for tying off a single tread makes finishing the piece much better and you don't waste so much tread as you can work more of it before needing to tie off. At the completion just simply work your needle a few beads away from the finish and catch a tread next to the last bead you executed from, put the needle trough enough to be able to wind the back cord around the tip end coming out , pull tread through and repeat again another few beads away , and snip off excess go back and do the same for the tail :) ALWAYS finish of bead work with a set of a couple of knots and never just by treading around a few... after time the tread will start to work out causing it to go sloppy and for sharper edged beads like bugle beads to go on a slant and cut the tread :)

Thank you. I love your jewelry accessories.

Thank you 😀

Спасибо большое !

Thank you)

Спасибо за ваш комментарий, мне очень приятно, что не зря снимаю. На счёт нитки: присоединяете так же как в начале , только цепляетесь не за кольцо, а за нитку в месте где закончили.

@@KristaStudio спасибо!! Конечно не зря. У меня чешутся руки)) попробовать, люблю рукодельничать. Но пока посмотрю только, много другого в жизни... Дождусь отпуска

Я Вас понимаю) сама без рукоделия не могу, но времени иногда действительно не хватает на всё))

I folded the thread in half and threaded both ends into the needle.

I changed the thread several times. More precisely, about 3 segments of 30 cm.

@@KristaStudio It's silly and lazy using a doubled tread like that.. there are some really good !!! vids on how to do it properly, lololol