How To: Motorcycle Coolant Flush (Yamaha R6)
Рет қаралды 47,158
Күн бұрынHow to change / flush the coolant on a Yamaha R6!
Fairing removal vid: • How To: Remove Yamaha ...
► PARTS USED:
Coolant: amzn.to/2xVvwst
Funnels: amzn.to/2xU2kBV
Catch Pan: amzn.to/2xjEcpt
Shop Towels: amzn.to/2wCCx0V
► Amazon Blockhead Page:
www.Amazon.com...
As always, thanks for tuning in all! Be sure to Like / Comment / Subscribe!
Till next time, you all ride safe out there, & stay vigilant!
Deuces!
▬
BIKES:
2017 Harley Low Rider S (FXDLS)
2014 Yamaha YZF-R6
1987 Honda Rebel 250
▬
MY GEAR:
Helmet: amzn.to/2vPA2Hz
Jacket: amzn.to/2qI7Hhb
Gloves: amzn.to/2q34V5i
Helmet Buckle: amzn.to/2opFNXK
Helmet Faceshield: amzn.to/2uxHlnk
RECORDING GEAR:
GoPro: amzn.to/2pr5fKo
Mic: amzn.to/2opG6C8
Mic Adapter: amzn.to/2onrSjy
Mic Windscreens: amzn.to/2oniCf9
SECONDARY HELMET:
HJC IS-MAX II Helmet: amzn.to/2o456vR
HJC Chin-Curtain: amzn.to/2owJ5sF
HJC HJ-17 Anti Fog Insert: amzn.to/2opRFJo
▬
► Shop! - bit.ly/Shophead
► Subscribe! - bit.ly/BlokHdYTSub
► SOCIAL:
Instagram - bit.ly/BlokHdIn...
Facebook - bit.ly/BlokHdFa...
Twitter - bit.ly/BlokHdTw...
▬
► MAIL TO:
Blockhead Moto
PO Box 18
Windermere, FL 34786
▬
BEER?
Lots of people say the channel has helped them in some way, be it the "How To" videos (mostly,) or other random videos. People are always saying they'd love to buy me a beer. I love beer. If you're one of those people, feel free to buy me a beer! :)
► Beer Me! - bit.ly/BHMPYPL
Note: Beer fund might be used towards motorcycle fund as well! (parts / maintenance / etc!)
▬
Music:
Tonez & Re-C - Kyoto: bit.ly/2o95eOL
Creative Commons - Attribution 3.0 Unported - CC BY 3.0: bit.ly/2o941XS
Music provided by AL: bit.ly/2o9aKkH
________
*DISCLAIMER:
This is only a guide, and not meant to be taken as the only means of completing this job. I assume no responsibility and am not responsible or liable, directly nor indirectly, for any damage or loss caused or alleged to be caused by or in connection with use of or reliance on any such Content, site or resource.
@TxJonathan 7 жыл бұрын
I'm a mechanic and with CARS after you put coolant you let the vehicle run with cap off to let air pockets out and to make sure it's topped off. Just my 2 cents.
@user-im1sn6hm4t 5 жыл бұрын
Run for how long?
@johnathandoerty1021 4 жыл бұрын
And, to get the mixing Ratio correct; He should have filled it with Coolant, let it run, and then Drain it --- so that way the remaining Distilled Water is flushed out. Then, fill it with new Coolant, again, "burp" it, and then top it off... At least, that's what I'm going to do! - Gotta keep it 'Cool' (😎)!
@hugoguimaraes9807 3 жыл бұрын
@@johnathandoerty1021 what do you mean by "burp it" Johnathan? Im about to do a coolant flush on my bike and I want to do it correctly, if you could help my endeavor, much appreciate it.
@BayArea.R6 3 жыл бұрын
@@hugoguimaraes9807 burp it means getting air bubbles out. Run it with the cap off and you can squeeze hoses to help get air out.
@hugoguimaraes9807 3 жыл бұрын
@@BayArea.R6 thank you for answering.🙏🏻
@RandomGuyComments 3 жыл бұрын
Thank you! 4 year old video, still helping R6 owners!
@justride9782 3 ай бұрын
Keep coming back to BlockHead R6 maintenance tips. The close up of the parts worked on is much appreciated. Whats up BlockHead!
@JuanTorres-qb5ob 7 жыл бұрын
Hey blockhead I would like to thank you for helping me realize my passion for motorcycles.
@blank2316 7 жыл бұрын
Love these videos, literally teaching me how to do everything on my 08 r6!
@Daraaggon 6 жыл бұрын
Hey Blockhead, when you're pouring oil or coolant hold the bottle sideways. It doesn't spill as much ;)
@carlosg6749 7 жыл бұрын
watching you and bike n bird is like going to school bro keep it up .
@hoodedr6 5 ай бұрын
Would this be the same for an 05 R6?
@JBLA 3 жыл бұрын
What about bleeding the system though ? It must’ve had air pockets after
@MakoVette 7 жыл бұрын
R6 has almost as much plastic as my Vette, dayumn :D Clear and well filmed destructions on how to do this chore though.
@BeardedWrenchh 7 жыл бұрын
i'm an auto tech, but not bikes...do you not need to bleed air pockets out on a bike?
@patrickhicks8912 4 жыл бұрын
clear and to the point. good video
@KelsS1k 3 жыл бұрын
I did these exact steps i filled the radiator until i couldnt the coolant went down lil bit i topped it off n put it in the reservoir, I let the bike run it went to 230 degrees idk Why tbh
@dewanejubara7021 4 жыл бұрын
I have an r6..very helpful thank you!
@YABUKIJOE2077 Жыл бұрын
Saving us money. Much appreciated
@mannypaniagua3788 Жыл бұрын
What about bleeding the system. I let mine run and it constantly overflowed out the reservoir and I’m trying to figure out how to bleed the system.
@YABUKIJOE2077 Жыл бұрын
Same thing here
@meh6953 6 жыл бұрын
Thank you for the informative video brother. I'm about to do mine this weekend.
@mauricesamsom131 4 жыл бұрын
what about air bubble ? at the end d'ont see when you remove air pocket
@HeyCoolStoryBabe 7 жыл бұрын
I see that sneaky 883 in the back Mr. Blockhead!!
@edwardlacika3022 4 жыл бұрын
The service manual also calls for disconnecting the water pump inlet hose for a complete drain. Not sure if that makes a big difference or not?
@Bryantrincon413 6 жыл бұрын
Looking like the Grinch with them gloves lol
@BaggerBro 7 жыл бұрын
AWSOME VID... I THINK IMA DO THIS ON THE FATBOB
@marceldealmeida6591 3 жыл бұрын
Sooooo much freaking fairings to take off!!
@johnjohnson1681 2 жыл бұрын
Great video
@omeryuksel1135 2 күн бұрын
My coolant is draining really slow idk what’s wrong with it
@MrKsaf Жыл бұрын
Thanks , this helped
@Bryantrincon413 6 жыл бұрын
Your a professional who works on his bikes in his garage 🤣
@alexventrov6826 4 жыл бұрын
What's the plastic reservoir for ? Is it for overflow? I never understood.
@RektIsGod 2 жыл бұрын
What temperature did your bike get to that the fans turned on
@S1k__fari Жыл бұрын
Mines got to 212 and shut off and fans cut on
@NoHypeJizzReviews 2 жыл бұрын
For a track bike this is one of the most in accessible bikes I've ever worked on its actually sad. No reason I should have to remove that much to fill my coolant
@hannguyen2634 4 жыл бұрын
How often do you flush the radiator and change coolant fluid
@warsok2151 4 жыл бұрын
Do you have video on how to replace fork seal?
@mhsucio6830 3 жыл бұрын
You should have cleaned the reservoir out, I bet there’s gunk in it. And you shouldn’t have left over coolant for the R6 with that coolant you should actually be a little short
@TheLegendaryLoso 3 жыл бұрын
Will this cause the bike to not start?
@colin9630 4 жыл бұрын
You don't have to bleed the coolant system?
@D1cko888 7 жыл бұрын
Was that concentrate you poured in? From my experience, the concentrate is thicker like you described until it’s watered down.
@dustyn13 5 жыл бұрын
:42 you can see on the bottom of the bottle it is premixed.
@yeysonherrera5600 Жыл бұрын
What type of water
@hassanjaveed9717 5 жыл бұрын
Hi my bike bubbling
@user-jo2mt7ir2x Жыл бұрын
Save yourself a trip, get 2 engine ice containers. One isn’t enough for an 08 r6. Btw^^^
@AakarshanB 7 жыл бұрын
Man..!! Your videos never work for me. Always take about couple of hours after the upload, before it stops giving me errors and hiccups.
@bevestush 7 жыл бұрын
Gotta get rid of these R6 vids fast. He's already bought something else. Lol
@MrMoonman76 7 жыл бұрын
Steve Bush probably last minute upkeep to get maximum profit out of it Edit: after hearing the part about them being wrapped you are right they are definitely old vids lol
@BlockheadMoto 7 жыл бұрын
Shhhhh......
@93ChayZ 5 жыл бұрын
KZfaq is already paying you, why are you asking for funds, this isn’t twitch 🤦🏼♂️
Sportbike Track Gear
Рет қаралды 128 М.
Fabiosa Best Lifehacks
Рет қаралды 18 МЛН
Swapmoto Live
Рет қаралды 13 М.