most clients wish to replace the original remote control with a general remote control, while such remote control has not be developed. You may configure your remote control within 2 seconds if you meet the following three conditions: Condition I: the original remote control may be used normally Condition II: frequency of original remote control is 433Mhz Condition III: IC model of original remote control is 2262 2260 1527 2240 and compatible IC (rolling code remotes will not work)Application method:1.Clear the copy remote controller: Long press the above two keys at the same time and release your hand when thelight flash quickly. 2.Copy: Press the button of the copyed remote control withone hand, and press the button of the new remote control withthe other hand, keep for a few seconds 3.Use:If all the above operation succeed, the romote control can be used directly. If it can not work, please operate again from Clearing4. Recover: If you meet misoperation and cancle useful codes, before re-copy, you can press the below two keys at the same time for 2 seconds and release when the lights flash quickly, then the control will be recoveredqiachip.comKIACHIP6.13K subscribersVideos9:13by qiachip.com 20K views 1 year agoAboutHow to Program Remote Control duplicator programming copy clone g....Newer version, more compatible