#battery #recovery #100 #diy #viral #viralvideo #automobile #video KONNWEI KW600 Car Battery Tester... www.amazon.com/dp/B07QYS4KRM?... DC Power Supply Variable, 30V 10A... www.amazon.com/dp/B0B7WBDXWN?...
Пікірлер: 15
@TSINED111 күн бұрын
You need time to let water goes to into glass mats , and start charging after that.
@user-yb2tp4qf1r2 ай бұрын
And I am watching this a week after I replaced my original battery with a Bosh AGM, which I hope to last even half of what the original one lasted (6 year).
@bradanesi399824 күн бұрын
How do you know how much water to add? I've added about 50ml to each cell, but the top of the "plates" are still dry. I realize it's different with an AGM and they should not be fully flooded.
@DIYDime24 күн бұрын
Try to charge now and after charging, test the battery. The goal is to get results, not to flood the cell. If no change in battery- repeat the process.
@bradanesi399822 күн бұрын
@@DIYDime Thanks for the input. It charges, but drops down to ~12.2 within a few hours once off the charger. A lot of heat was generated, so thinking I'll repeat.
@DIYDime22 күн бұрын
@@bradanesi3998Make sure you charge the battery with low amps. If you have infrared meter you can check each sell to see if they perform same temperature. If one of them will give high temp then the other one it could be shorted.
@quichung7472 ай бұрын
Hi where did you buy the power supply ?
@DIYDime2 ай бұрын
DC Power Supply Variable, 30V 10A... www.amazon.com/dp/B0B7WBDXWN?ref=ppx_pop_mob_ap_share
@quichung7472 ай бұрын
Thank you so much
@hswing112 ай бұрын
@vicc67442 ай бұрын
did it start?
@DIYDime2 ай бұрын
😂Yes it did! Working like new
@jethrobenjiro14 күн бұрын
@@DIYDimehow many water u add? Zuur or not?
@DIYDime14 күн бұрын
@@jethrobenjiro in my case it was only full syringe for each cell
@markvietti2 ай бұрын
there you go people just add water to your bad battery and it will be like new.