Hi there! In order to remove the camera I wiggled it carefully back and forth a few times and it came out, since it's just glued inside. After I applied the decals I opened the model, so that I can reglue the camera at the same place it was from inside. I used a resin glue for it. I don't know if the wheels can be taken off. This is a problem for many minichamps models - wheels that don't spin how they should spin. I don't think that the lubrication is the problem but the way they are attached and the bad quality control.

I didn't remove them. I applied few layers of white decal paper and after that I applied the Marlboro decals

@@MegaRaduB1 thanks! Yes I can see the decal sheet has one for the front and back of the rear wing. How many layers did you add until you were happy the barcode didn’t show through?

Well it depends on the thickness of the decals you are using. I applied about 4-5 layers.

@@MegaRaduB1 on the plastic rear wing, you could try using MicroSol decal solution to remove them.

Sorry for the late response. I wouldn't advise you to use this solution on plastic/resin parts! Use it just on diecast otherwise the paint could be damaged.

@@MegaRaduB1So if i use this acetone on 1/43 models on the metal parts , will it still affect the paint job? My cars colour are red, but I try to remove the decals from my red Ferraris to keep them clean