How to Remove Prop Shaft Correctly, Mercury Lower Unit With Cam Shift.

No video

How to Remove Prop Shaft Correctly, Mercury Lower Unit With Cam Shift.

Рет қаралды 42,606

The Guy From Finland

Күн бұрын

Пікірлер: 16

@FUNKER420 11 күн бұрын

Dude, amazing job on the video you deserve more subscribers for sure, you just saved me from destroying a lower unit. Cheers 🍻

@AmazonJungleFishing455 6 күн бұрын

Great vid , took power head off pin must have slipped you have saved me a lot of time great to se problem thanks

@juliebluhm5508 5 ай бұрын

Shift Shaft : Great presentation. I've been looking on the net for 2 days, Day 3 The Guy From Finland Pops Up 👍Thanks I Have a 1989 Mercury 80Hp Runs Great. 1st of November I Sucked Sand into the Pump. I Cleaned the Pump and Reused it So I could Go Out the next Day. I also changed the Oil at that Time. I only went out 1 more time Before The Ice Hit. So the oil Should have been good. I Just Installed a New Pump and Pulled the Plug to Change the Oil and the Oil was Milky. Pressure Tested and Found the Shift Shaft Seal Was Leaking. Pulled the 2 Bolts and Pried the Seal housing up. When The Housing Came Free The Shift Shaft Popped up like with Pressure and Now The Shift Shaft Just Spins. I can See at the bottom of The Shift Shaft Tube the Hole the Shift Shaft will go into But The Shift Shaft Just Bottoms out . I'm Thinking The Pressure of The Prop Shaft Pushed the Shift Cam back. I Think If I remove the Bearing Carrier and loosen the prop Shaft the Shift Shaft might loosen up enough to Line the Shift Shaft back Up . I'm waiting On "The Book" To Get a Better Look . I've Subscribed so I'll Look at A Few More Of Your Videos Before I Tear Into It. Your Videos Are Great and Explain the Process Very Well. Thank You Much . I'll Be Looking Back Soon. Oh Yeah This Is Jim.

@fishelectronics 5 ай бұрын

Thanks, Jim. I'm not sure I'll be hitting rocks too often for more content like this :) but I can always find what to renovate in my boat and make a video on that.

@insidethecomputer 2 ай бұрын

Very informative video. Your English is very good ❤

@fsp500 7 күн бұрын

Hi. Why is reverse gear stuck and how did you take it out? Mine is stuck and won’t Go out

@reedsutter8485 20 күн бұрын

Can anyone tell me the size of wrench you need to remove the driveshaft pinion nut on a 150hp? (see minute 17) I need to remove mine because I didn't watch this video first. I need to grind a wrench done narrow enough and I don't want to guess and find out I'm wrong after grinding the first wrench. Thank you in advance!

@tonyzizzo3165 25 күн бұрын

i did mine now reverse does not work

@gptrichnyc 2 ай бұрын

Thanks!

@kaytong9533 10 ай бұрын

Hi i have 60hp mercury and got a small chiped on the front unit where u cut it on your Its is bad?

@fishelectronics 10 ай бұрын

I don't think chipped affects anything if everything works fine. Or probably you are actually talking about a special hole for the pito sensor that looks like chipped.