I actually have a set of thread chasers but I never new they were used to repair threads. Another good video. Have a good one.

Exactly what I was looking for. So much easier when you know the name of the thing your looking for!!! A+++informative!!

Awesome tips saved me a trip to the mechanic! Thank you!

Dude, saved my butt. Bought some threads chasers and fixed my problem! Thanks a ton.

Great video was thinking of getting a die, never thought of thread chaser. Try little oil first helps to save chaser an cuts easier then dry redo. Thanks very helpful

Another great video 👍🏻 you have had the wheels off your car so much, Lol i always learn something watching your videos

great vid. my mechanic just screwd up two of my threads.. what happens when you use powertools from the get-go 🙄

Great editing!

Thanks for sharing. Very useful.

That was a great video. Do you know the size of the thread chaser for a 2005 Acura TSX ?

Alot of thanks I need a tool exactly like this

U mean to tell me I didn't even have to replace my studs? Lol

Thanks, had 2 lugs really hard to screw on. Tried this an they spin on nicely now.

a bit confused on the sizes. what is the correct size for a 14mm x 1.5 stud ?

I have a Rt/10 did you order the 1/2 size

Thank you that help a lot

Would using some lubricant help ?

The Die that you showed Amazon fits the Wheel Studs on most cars, I imagine?

Is that a Boosted SRT4 Neon? 😝

How do I know what size to get?

What size is that ??

What do you do with a broken stud. I was trying to get these old nuts off and they were literally Rusted in/Fused to the wheel.. and when had scaffolding bar and tried moving the nut.. didn't work as it was literally stuck right in there.. so I swapped to longer scaffolding bar and the nut came off, But unfortunately so did the stud supporting the nut... Devastateddd!!!! I take there's no way to repair a broken stud.. It was literally my last nut as well.. all had gone well up until that final nut.. where I never seen that happen before... closest I came to was actually sheering the tool I was using to take out the nut.. but never the nut itself... until literally just then... I had to de-seize/break off 36 nuts and all of them were fine.. all bar for that one god-forsaken nut... Problem is... Its on an old truck trailer.. the studs are PART of the hub itself... so its either I get some other stud and weld it on with same/similarish nut (unlikely), or I basically replace the hub cap entirely... by removing one I de-rusted (front wheel) and replacing with some miracle of a hub that happens to fit (very unlikely too)... it bothers me so much.. I wish I could just take the hub.. 3D scan it.. and have a new hub cab printed off the scanned 3D model of the hub... in the same material... Steel Material.. But I imagine the Expense/Cost of doing that would be pretty high...

Wat size did you order

What size do I need for a 2001 Subaru Legacy. Got some misthreaded lug nut studs.

Great video but the music is not necessary.