Disassemble karcher dirt blaster if lance is stalling. Not spinning. Clean dirt and debris inside and it will spinn again #karcherdustblaster #dustblasternotspinning #db145
Пікірлер: 24
@polishlocks3 жыл бұрын
Here is the way that helped me. The nozzle jammed and gave a straight stream, the pressure was ok. What I did: "I found a way to start the nozzle without disassembling it. Just squirt the lithium grease in the spray inside the nozzle from the outlet side. Lubricating even a wet nozzle makes it run like new. 20 minutes. Then you have to repeat it and the working time is longer. Fairy tale. I recommend it. I used CX80 Lithium lubricant. " My nozzle got a second life, after a few cycles with grease, I washed 350 square meters of the driveway. RECOMMEND
@glennfowler5012 Жыл бұрын
Thanks brother, I was afraid to try to twist off the cap as it was like it was welded on. Your video gave me the courage to break out the vise grips and channel locks. It still was scary as the bugger was really stuck. I then put a little wd40 and some heat to it and finally, it broke free.
@amitantil Жыл бұрын
Glad it helped 👍💯
@PaulGDowling Жыл бұрын
Worked a treat. Thank you!!!
@amitantil Жыл бұрын
☺☺
@TheSweeney-UK2 күн бұрын
The ball bearing needs to protrude more, one fix is to place a small washer or two under the ball to raise it .
@PROGAMERrt1079 ай бұрын
❤
@dagored40773 жыл бұрын
Fixed! Thank you.
@amitantil3 жыл бұрын
Ur wlcm 💪🤘
@Pavleone2 жыл бұрын
Can someone tell me what is the size of that o-ring ?
@giovannipg30003 жыл бұрын
Nice...i fixed mine ...thank you !!!
@venugopalmk2636 Жыл бұрын
Good
@amitantil Жыл бұрын
Thanks
@MoongaNyanga6 ай бұрын
How can I disasemble the gun
@polviggen Жыл бұрын
Didn't work. Just bought a new K7. First one broke within 4 hours, second one lasted 2. It's a crappy design. I took it apart and could not find any dirt
@amitantil Жыл бұрын
Problem is in design
@robmcphillips66402 жыл бұрын
What a load of crap, you didn't even clean it properly. The bearing was in too far to work properly ha ha
@harry13074724 күн бұрын
There's a much easier way to fix it. Take the dirt blaster off, drain any water out and dribble some ordinary oil down the outlet hole. That's it, no dismantling needed.
@Frenchtoon3 жыл бұрын
Didn't work
@rafal870810 ай бұрын
actually you didn't fix anything. You've just disasebled the nozzle and that's it.
@amitantil10 ай бұрын
And it worked 🤣
@alfching24992 ай бұрын
All you did was take it apart and put it back without any result
@amitantil2 ай бұрын
Thats the point to remove debris you need to take it apart and to make it work again you need to put it back