If you need parts or accessories for your BMW click the link below: BMW Repair Ista/a Ista/p Access bmwtechinfo.bmwgroup.com/#/login BMW Accessories amzn.to/3HDeBvA BMW parts info amzn.to/3qO15xD
Пікірлер: 47
@Fasil7772 жыл бұрын
You saved me so much money. God bless you. Do u recommend of putting computer cooling pads inside and outside the module ?
@ompatilebutale39083 жыл бұрын
This was really helpful, thank you!
@BestCarFixes3 жыл бұрын
Glad it was helpful!
@jorgemora71908 ай бұрын
Wow grait video really interest we always learn something every day thanks. For u time
@BestCarFixes8 ай бұрын
My pleasure
@Smile107102 жыл бұрын
is there anywhere you would suggest i buy an EKP module and can take it to get coded? my EKP has been failing for a couple weeks now and haven’t been able to find any
@BestCarFixes2 жыл бұрын
Call me 3472281875
@CxJason2 жыл бұрын
You know your shit my friend
@jonredd650 Жыл бұрын
Where can i get mine programmed
@akflaco9197 Жыл бұрын
I just got this job done started up fine after the job now won’t start does this reset itself when you take out the fuel pump relay?
@BestCarFixes Жыл бұрын
No, just see what codes are there do regular basic test first
@cierareed75692 жыл бұрын
Hello, I have 2011 bmw 328i xdrive yesterday drove fine needed went to get gas car started to slow down shake and cut off got gas and it’s started got home it cut off and tried to start again start and turn over then loose power don’t know where to start does the same start in stop as seen in video could it be the fuel pump ?
@BestCarFixes2 жыл бұрын
run a diagnostic frist
@Silva3sp2 жыл бұрын
Hi I have a 2009 BMW 328i yesterday I drove the car fine no problem then last night I went to start and it would crank but not turn over. I hooked up my car scanner and got 2 codes 1. 2ded closed circuit current violation and 2. 2DA6 (electric Fuel pump) Faulty, receiver DME. Transmitter EKP I tested voltage on my battery and at the terminals and have 13v after cranking it a few times.
@Silva3sp2 жыл бұрын
Would appreciate and quick help as this is my only vehicle. Thanks if you can get to it
@BestCarFixes2 жыл бұрын
if you have EKP related code it could be fuel control module not good
@Silva3sp2 жыл бұрын
@@BestCarFixes okay and replacing the fuel control module I need to get that programmed or can I buy a used one from a similar year and would it work?
@Silva3sp2 жыл бұрын
@@BestCarFixes my fuel pump Fuze was also blown but completely melted. I don't want to just replace the fuse and it just blow it out again
@lin-qj9qk Жыл бұрын
@@Silva3sp Update? My module,pump, filter are both blown
@andresluna42593 жыл бұрын
What are the symptoms of this failing? I currently have a 2011 BMW 328i that cranks and does not start. Replaced alternator.
@BestCarFixes3 жыл бұрын
is the car start and run before you change the alternator
@andresluna42593 жыл бұрын
@@BestCarFixes car has 70,000 miles. before I had issues with my car, I started it up to warm up maybe 5 minutes and it suddenly turned off and engine was off. I tried starting it up and it would crank but it would not start. I figured the car didn’t start because the alternator so I replaced that and I still have same problem as before. The battery goes low after trying to crank it 10+ times. I had it charged twice different shops and they both said te good. I checked fuel fuses and they look good and I’m starting to wonder if it’s a fuel pump issue
@BestCarFixes3 жыл бұрын
check this link i made it for you it may help you fix that car kzfaq.info/get/bejne/qrSGmJaJzJrZXYk.html
@BattleRatsRapBattles2 жыл бұрын
So my 2011 328i e90 stalled out today while driving. No warning, was driving perfectly fine. Has 65,300 miles. Stalled out, the service yellow light came on, I checked the code, it read CC ID 309. Which was fuel pump malfunction. It wouldn’t start up for about a half an hour. Waited and it started right up and I drove it home. The code wasn’t on my dashboard anymore either. What is the suggestion? Fuel pump itself, module, could it be bad gas? I’m super confused.
@BestCarFixes2 жыл бұрын
run a diagnose to see what code you have it could be any thing from fuel pump control module and so on
@urstillweak58052 жыл бұрын
did you figure out what it was? i have the same issue and bmw diagnosed it was the ekpm and fuel pump
@BattleRatsRapBattles2 жыл бұрын
@@urstillweak5805 I changed the fuel pump and it’s not stalling out. But now I also need Vanos Solenoids and I’m almost positive I need a PCV valve. I’m sick of having a BMW lol. Almost
@BattleRatsRapBattles2 жыл бұрын
@@urstillweak5805 make sure to check your fuel pump sender tho. It’s behind your passenger side rear seat. Towards the inner part of the door. You can check the voltage on that before you just change your pump. If the voltage is good, change the fuel pump. Of the voltage is reading low, it could possibly be that fuel pump sending unit. I learned that from my car being fucked up lol. Good luck.
@amaghana95992 жыл бұрын
Please Do you also drive to the customer’s location and program the module too?
@BestCarFixes2 жыл бұрын
sure if you are not far
@aaronmedrano3777 Жыл бұрын
Where are you located??
@OOrtiz872 жыл бұрын
I bought a new module and installed it without programming and the car turns on. It still has a rough idle but it hasn’t turned off on me yet. I thought it wasn’t suppose to turn on if it wasn’t programmed. Have you seen this before?
@BestCarFixes2 жыл бұрын
yes some of them work but it is better to program it
@OOrtiz872 жыл бұрын
@@BestCarFixes I appreciate it, I’ll get it programmed and hopefully it’ll help with the idle too. Thanks.
@ompatilebutale39083 жыл бұрын
What is the name of this program and where can I find the cable that connects the computer to the car? Thank you.
@BestCarFixes3 жыл бұрын
this is the link it kind pricey but its a good tools about 6000 with one years subscription www.microtronik.com/order-online/autohex-ii-bmw-full-package-ahx0005
@user-jh3yj6xn1t6 ай бұрын
Do you know where I can get the software to program the EKP?
@onefunnylaugh6 ай бұрын
Protool
@josecuin89810 ай бұрын
What if I bought a used one would I still need to program it?
@BestCarFixes10 ай бұрын
yes the coding some time is different
@josecuin89810 ай бұрын
Okay thank you very much
@bmwsafi2 жыл бұрын
What software did he use?
@BestCarFixes2 жыл бұрын
authex
@Saiyan5852 жыл бұрын
Protool> Quicker, easier, done with a phone.
@BestCarFixes2 жыл бұрын
thank you for your info there is a lot of tools out there do the same, this is what i have for now thank you for your info
@patricioaguayo9088 Жыл бұрын
Hello there, please let me know about this protocol. Thank you
@rogervonschleusingen4603 Жыл бұрын
way way way to complex, not necessary, todays cars are shit !!