Awesome thanks for the sub!

Thanks for the compliment! 👍

Yeap! you can totally do that if your light casing is not out-of-date

That's a great question! I share the same thoughts when I first did the unboxing. I think it will be a hassle to unscrew the LED from the base plate because the 3-section LED is being secured with a total of 9 screws, if we consider replacing the driver, that is an additional 2 screws (total 11 screws). But once we get past that, you will be able to use the magnetic LED panels. In fact, the same retailer is selling at just $12! Quite a decent deal if you ask me. The link is too long to be posted here but you can just do a quick search on Lazada for "beacon led light panel".

I think you are referring to the LED driver, yes you can find compatible ones and replace it. I did that recently with one of my lights but it wasn’t very economical. The full LED lamp cost ~$26 and the driver alone cost $16. It probably better to just buy the whole set and keep the LED light as a spare incase one burns out

@@kakilai thank you for your reply and this video guide. I will go for a set instead. Cheers from HK

The old one has 2 lights that can be used independently. It’s single switch so you need to on/off to toggle which light you want to switch on.

@@kakilai wha, your lights all so sophisticated (expensive). Wonder what is the toggle called and whether u can still salvage and reuse (no wonder your old light has another device besides the ballast). Sounds like good idea to save electricity, so can have 2 bulbs, one much brighter than the other, so as to optimise electricity use (reduce wastage).

Hi! Unfortunately, I haven faced that issue myself and I don’t have a solution for it..

this isn't magnetic and you shouldn't need to use glue for this DIY

Thanks... I saw taobao only few dollars.. can I buy from there ? And also buy ceiling led light need to have safety mark or tested passed label either one will do or both or no need to have it?

You can either do a full replacement or just unscrew the existing LEDs and replace it with new LEDs that has magnets beneath to easily install onto the original light’s base plate

sub us first bro

Hi, it is best to seek advice from a local hardware shop in the UK, so that in the event that the light doesn’t work, it’s easy for you to get a replacement from them. I typically do not buy lights from unknown online retailers for safety reasons. In Singapore, retailers are regulated and the products they sell have to meet certain safety standards to protect consumers.

Yeap that’s true, you can either just cut a slot on the plate or just install it without any modifications which was what I did. The plate will be warped a little but it doesn’t affect anything

@@kakilai tks

it been awhile since I installed it,but it’s very light probably around 100-200g

Hi, just to clarify the LED lights are not dimmable. You can replace the LED itself by buying this www.lazada.sg/products/beacon-led-light-1415182024303536w-led-magnetic-panel-light-round-rectangle-panel-light-ceiling-light-panel-led-light-plate-ceiling-lamp-source-easy-replace-up-to-2-years-warranty-i515656321-s1522842201.html?

It’s not possible to change the sequence for this lighting

Hi! Sorry for the late reply! You can contact Mr Andy Ong, his contact number is in the video description!

I didn’t do that cause the camera will auto adjust the brightness, so you can’t tell the different before and after. Oh and also the room is in a mess 😅 but you can be sure it’s bright enough for a normal hdb size bedroom/study room

@@kakilai oh ok 👍🏼

Hey! The the one I used was 4 steps -> kakilai.sg/products/tolsen-62684-steel-ladder

@@kakilai wah you very tall or step on the top step I think