How to replace factory front speakers in a 2010 Toyota Corolla Le.

No video

How to replace factory front speakers in a 2010 Toyota Corolla Le.

Рет қаралды 31,999

Күн бұрын

Instructions on how to properly remove factory 6 1/2's in the front door panels of a 2010 Toyota Corolla Le. NO SILICONE NEEDED. Easy and simple instructions.

Пікірлер: 55

@pookiewood Жыл бұрын

Thank you for both of these videos! It made it a breeze! My speakers just died and I finally realized it. I bought mounting brackets that worked great. I had to use a screw to pop the broken, left over rivet pieces out once I got the speakers out. I reused the foam ring on the old speakers because I didn't buy any. It came off without breaking and attached just fine to the mounting brackets I used. To mount the new speakers, I used machine screws, washers and nuts. I put the nut and washer on a piece of duct tape, made a hole through the nut and washer into the tape and then attached that to inside the door so the screws could catch. Worked great!! Putting it back together was easy. Just popped the panel back on. Way easier than the rear speakers! :D

@righteousredneck777 Жыл бұрын

Very welcome! I'm glad ya got it done and happy the videos helped out.

@kenshinpa 2 жыл бұрын

Good video! I was able to copy with my 2011 Toyota Corolla.

@righteousredneck777 2 жыл бұрын

Good deal

@andresjc502 4 жыл бұрын

I just watched ur video I’ll buy the same speakers that u installed , hope they sounds good 👌 🔊 ,

@righteousredneck777 4 жыл бұрын

They do!

@andresjc502 4 жыл бұрын

Righteous RedNeck thanks , but they’re not available no more but , I ordered theses ones Pioneer TS-A1670F 3-Way

@edwinescobedo496 3 жыл бұрын

How many watts rms does the speaker have to be for the stock head unit?

@netrogenqatar3782 5 жыл бұрын

Nice job

@williamjueschke9960 4 жыл бұрын

Thanks, great help.

@righteousredneck777 4 жыл бұрын

Glad to help! Thank you for watching

@patrickjohnson5585 5 жыл бұрын

I don’t have the quick connect. Can I still have the wires spliced?

@righteousredneck777 4 жыл бұрын

You can direct wire

@chemlab12345678910 4 жыл бұрын

What speaker did you use? Anything I should look for when finding one?

@righteousredneck777 4 жыл бұрын

I mentioned in the video the model number on the speakers. I would go with a 3-way speaker. More Dynamic Sound

@TronApostle 3 жыл бұрын

So with those pioneers you can just plug them in and theyll work? I have this same car and dont want to have to deal with rewiring anything. If thats the case I'll def grab these and swap them out with my stock speakers if it makes a noticeable and positive upgrade

@righteousredneck777 2 жыл бұрын

I had no issues wiring. Bought about and play harness. Connects to the speakers and then directly to the original factory harness leading to the original speakers

@connorh2908 5 жыл бұрын

Were you able to fit your door pannel back on without modifying the speaker grills? I did the same thing with my 2014 corolla. I used a jbl 6.5 component set. Unfortunately the mounting height of both the OEM speaker adapter coupled with the jbl was too long so my door pannel didn’t clip in completely. I ended up buying the metra 82-8148 adapters.

@righteousredneck777 5 жыл бұрын

It's very important to leave the speakers bare. What I mean by that is they always come with a plastic grill that goes over them... Do not use that as that will make it stick out probably too far. I had no issues with these Pioneers at all. Door panel went right back on

@Esk8WI 2 жыл бұрын

@@righteousredneck777 hey man sorry this is an old thread, but does the grill actuallly affect this? ive padded the shit out of my door panels and around the speakers and i get rattle... would you suggest the grill go? does it affect the speaker in any way negatively over time? i assume the main reason for it is dust protection but id like your input

@siniestro0239 4 жыл бұрын

What a crap design from toyota, same with the rear speakers you have to take the whole back down to remove them. I'm replacing the speakers this weekend. Great video. Thanks

@righteousredneck777 4 жыл бұрын

Thanks for watching

@slickonlive27_99 2 жыл бұрын

Thxs boss

@righteousredneck777 2 жыл бұрын

Very welcome. Hope this helped

@andresjc502 4 жыл бұрын

I got a question buddy I don't know which wire is positive and which wire is negative. One is /pink and the other is a purple which is the positive wire ? I installed mines today but I’m not sure if I did properly 🤣

@cionol 3 жыл бұрын

Pink is positive

@Seansolo420 4 жыл бұрын

How did you find the quick connection

@righteousredneck777 4 жыл бұрын

Amazon...just researched a bit

@angelobertolo9264 4 жыл бұрын

Hey.. I've some 6' inch speakers, does it fit without using silicone?

@righteousredneck777 4 жыл бұрын

6 inch I believe is a bit bigger than the factory speakers. Might have to use silicone

@calebromero830 3 жыл бұрын

Did u buy the harness that connects to the other harness separate?

@righteousredneck777 3 жыл бұрын

Yes

@Leo-ef2tc 4 жыл бұрын

What exact adapter is it

@righteousredneck777 4 жыл бұрын

Plug and play speaker adapters

@omarhameed 2 жыл бұрын

why not 6.75 as the manufacturer did before?

@righteousredneck777 Жыл бұрын

Just what I went with and they sound great

@tmurray 5 жыл бұрын

What adaptors did you use

@righteousredneck777 5 жыл бұрын

Used direct fit quick adapters. Plug n play

@popoygravy5118 2 жыл бұрын

Sir what screw size is fit to mount the speakers to the door panel?

@righteousredneck777 2 жыл бұрын

Can use what size you like,but they don't need to be very long. You are only looking to secure

@carnynja9966 4 жыл бұрын

Gosh dang it I just want to know which one is positive and negative

@jaymfbreezy7530 Жыл бұрын

Did u end up finding out which one positive and negative

@zoop34 5 жыл бұрын

What size sheet metal screw did you use? Thanks!

@righteousredneck777 5 жыл бұрын

The size will not matter just use something that has a decent head on it like what you see in the video and just make sure that the drill bit you use that the screws are a little bit bigger than the drill bit and you will be fine. About inch and a half screws is all you will need

@zoop34 5 жыл бұрын

@@righteousredneck777 Thank you for the reply. Your video is helpful (and humorous).

@righteousredneck777 5 жыл бұрын

@@zoop34 ...Thank you!

@righteousredneck777 5 жыл бұрын

@@zoop34 ...no issues here. What size speakers are u going with??

@righteousredneck777 5 жыл бұрын

@@zoop34 thats strange that they would be bigger in diameter. You might be able to do some mods to the door panel speaker surround.