HOW TO Replace Hayward Temperature Sensor // Pool Series

Рет қаралды 25,902

2 жыл бұрын

Replacement Temperature Sensor: amzn.to/39VYe0t
Lube Tube (pool o-ring/gasket lubricant): amzn.to/3wg07xM
Non-Contact Voltage Detector: amzn.to/3PzLvBd
(paid links) As an Amazon Associate I earn from qualifying purchases.
In this video, we will walk you through the step-by-step replacement of a pool temperature sensor. We are replacing the Hayward Aqualogic sensor with an Optimum Pool Technologies generic replacement. The repair steps are the same for Hayward, Pentair, and other major pool brands. Be sure to SUBSCRIBE to check out more DIY repairs, tips, and tricks in our HOW TO Pool Series!
#poolhowto #diypool #haywardtemperaturesensor #pooltemperaturesensor #poolrepairs

Пікірлер: 14

@richardthe13 9 ай бұрын

I’m a pool service pro and watched this video as a quick refresher. It’s spot on, thank you!

@MRGREGSHOWTO 9 ай бұрын

Glad to hear it, partner! Really appreciate the feedback from a pro.

@sandracausey7026 Жыл бұрын

Thanks so much!!!

@MRGREGSHOWTO Жыл бұрын

You're welcome, partner! You can too!

@danielmccartney7860 3 ай бұрын

Thank you

@MRGREGSHOWTO 3 ай бұрын

You’re welcome, partner! You can too!

@themorfeeis Жыл бұрын

Seriously appreciate the video. My installers didn't install my temperature sensor and I had no idea where and how to place this. Any idea what size drill bit what best make the hole?

@MRGREGSHOWTO Жыл бұрын

You're welcome, partner! I would guess just to drill a hole slightly bigger than the probe. You need to make sure that the rubber o-ring will seat well and create a good seal. Also, be sure to release water pressure before drilling. Let us know how it goes!

@tiagaodoopala826 Жыл бұрын

Preciso trocar o sensor de leitura do sal seria o mesmo procedimento?

@MRGREGSHOWTO Жыл бұрын

Howdy partner! If your salt sensor is bad then it is probably related to a faulty salt cell generator. Hope I understood your question.

@ronaldwade6716 8 ай бұрын

What size drill bit did you need for the sensor?

@MRGREGSHOWTO 7 ай бұрын

Howdy, partner! I don’t recall off hand and can’t check without removing the sensor. Just make sure the one you use is slightly larger than the sensor piece, but smaller than the rubber o-ring and you should be good. Let us know how it goes!

@ronaldwade6716 3 ай бұрын

What size hole is that? If I need to drill one for a new sensor

@MRGREGSHOWTO 2 ай бұрын

Howdy, partner! I don't recall exactly. If you have the sensor just drill a hole a tiny bit larger than the probe that you need to insert. If i had to guess I would say about 5/8".