I respect the fact that the truck is clean

Hey thanks man it was nice to know everything I needed for the job. First time doing the job and took under an hour. I taped the joints to all of the ducts the duct tape. I did the same back in the bunk it helps it blow harder

I hit blover motor location now it works properly Thank you🙏👍🙂

In the middle of replacing my fan on my 2003 volvo this was the same and this video did the trick big thanks , you should keep posting videos

Just a little tip. You should have started removing that top moulding over by the gauges first. It's way easier

Thank you so much man. I watching this video and doing my truck. Thank you again.

The blower fan is supposed to hesitate before starting. This truck has electronic climate control. Notice that it has actual temperature settings, not just red for hot and blue for cold. The computer figures out what the ambient temp is so it knows what speed the fan should be turning. This will occur when the fan is set to ‘Auto’ or set manually to the speed you prefer. The a/c on and off switch was probably sticking because of the poor decision to locate it near the cup holder and it has liquid splashed into it. Spray some contact cleaner around the button and work it a few times. The control unit behind the controls is very expensive and it can wreak havoc with other components if you change out blower motor or resistor with the key turned on. A new one has to be programmed in with a laptop. I found this out the hard way. $$$!

Thanks, just replace my a/c blower following your video......

Thanks brother. Hitting the blower motor restated it. Thanks

Thanks, just changed my blower. Diagnose helps cause that switch modual is 350$

Thank you 🙏🏻 you’re damen i save a lot money because of you 👍👍👍👍

I just gave it a solid punch at the blower area like u show it and starts working thanks

Thanks for sharing! Very helpful! Did this deed today!

Thanks a lot!... Right to the point!

Same issue going on with me but when I hit the lower panel it does not turn on. Fuse is fine as well. How would you diagnose the blower motor resistor?

Muy buen video ...gracias por subirlo Un 10....

This just happened today on me, if you knock on the panel on the passenger side you might get it working temporally

Very helpful video thanks

Excellent,Thank You!

Thank you helped me out

Thank you sir 👍🏼👍🏼👍🏼 you are the best

Mines is blowing heat.where are the blend doors module?

You're a fucking life saver

Hey. What brand is eld in this truck??? That mount looks clean as well.

This has like thousand screws and clips