How to Replace the Down Stream Oxygen Sensor (o2 sensor) on a Ford Escape 1.5l Ecoboost 2017-2019

Рет қаралды 16,908

Жыл бұрын

In this video I demonstrate how to replace the downstream o2 sensor on a 2019 for escape 3rd generation. This will be the same for all 3rd Gen Escapes with the 1.5l Ecoboost (2017, 2018, 2019).
In this vehicle the heater circuit on the o2 sensor had failed which tripped the check engine light.

Пікірлер: 48

@SeunOjedeji Жыл бұрын

Just to change the 02 sensor? Wow!

@nathanlawson2523 Жыл бұрын

I hate the engineers who thought this was a good design. Great tut though thanks.

@asallee2

This is insane how the engineers engineered this engine. You could tell that engineers that bill these new engines don’t actually work on them. Day in the day out.

@fynetuneyrgf

Very good instructional video bud. I work on way to many cars to be able to remember each step and little trick, even after doing the same job a couple of times. You got the video time down to around 15 minutes, which is perfectly the right amount of time to use your instructional as a refresher at lunch. Which saves me time, due to not having to think up and remember what to do next, smooths things out nicely. 👍

@christopherstaffondpeterso1820

The mechanic did a great job, but all of this just to change a O2 sensor.🤦🏿‍♂️

@lildevilchild23 Жыл бұрын

Everything in these vehicles is a joke to work on....

@bobedwards7927

Crazy how you need to do all 😢hat to change an o2 sensor

@lakelyman4958

2.0 eco boost has the connector behind the motor. Easy to see once you remove the battery box

@nalaleah Жыл бұрын

In my Escape, it's FWD. I see the reduced labor cost of not needing to remove the drive shaft. In a perfect world, you would have commented on that possibility, but I'm betting all the under shield details apply. I may try and skip the battery box removal and comment if I am successful. Regardless, you have produced a GREAT video!

@daveb3599 14 күн бұрын

Ya. The 17s and 19s are different

@Gruin 14 күн бұрын

Great Video Showing Very detailed Display of Many, Many little parts to Remove.Thank You For the Time it Took to Put this Production on Line.

@kenjohnson1280

This is one of the best instructional videos on KZfaq. Great job. Notes for anyone looking to do this:

@dennisweatherman8815 Жыл бұрын

Great video quality. In my opinion the best Ive ever seen on youtube. I retired from the industry 10 years ago and sure glad I didnt have to do any of these. However now my wife owns one and has P0141. Fun times ahead!

@ropts91

This video was super helpful 👍🏼 I fortunately did not have to disconnect the driveshaft only the cross member I heat the sensor with a torch & was able to get it off like that thanks for this though 👍🏼