Hello my dear new friènd very good rewinding..👇👇👇👇🤝🙏🏼

Trimakasi, mantap job but you should press hard each coil to prevent from shirt circuit (default shunt between coil 1 coil 2 and coil 3... thanks, inchallah if i need i will do same. Salamalikoum from France

Maraming salamat kapatid sa pag bahagi ng video sa pag rewind ng coel ng motor,,

Very useful

Like

I have not ever done this, although I bet it is monotonous you may wish to try and tighten up every layer before putting another on top, that way the last phase will have room. I'll be back to apologize after I try this myself within the next week

For a better job you need to wind each turn tight and layer them. Also, remove the old varnish buildup first!

Tama kayo boss may nabaklas Ako gauge 19 talaga

If the wire is 1.15mm, can we put a 1,10 mm wire. Won't it be dangerous?

How many meters that it takes?

hello, take it easy, I'm reaching you from Turkey, there is ns 200, the stator burned out, I took off 50 turns, I wound it 45 turns, but I didn't try it yet, do you think it would be possible to remove the conjunctor? can you give me information?

Can u mention how many turns need for each windings

Mrning ask ko lang po saan ba tayo maka bili ng ns 200 stator po

boss 19 gauge diay imo gamit? bwesit tong indiano una nag post 22 gauge iya gi ingun, gi double nalang nako ang wire para dili ma sunog. hibolong ko kay gamay ra kaau ug wire..

Pag staytor ng supremu bos ilang ikot.

🤣🤣

location nyo po sir wayne papa rewind po ako sana eh salamat po

Sir kahit ba san magsimula pwedi po ba

Sir bakit ang reply skin ni thor na nagrerewind din eh gauge 21 ang wire? Bakit sayo 19?ano talaga ang tama nyan na sukat?

Paps Saan poh ikabet ang ground ,,,kc phase yan,, tatlong yellow

Coil wire is too loose, you need to practice

Peça ficou tão feia , que o cara até peidou kkkkk