How to test vvti camshaft timing oil control valve of toyota Camry#HowToTestCamshaftTimingOilControlValve#MayoCarsDR
Пікірлер: 46
@nathancaldwell86203 жыл бұрын
Yay it's a piano telling me what to do
@bascondavid2 жыл бұрын
Good video... Welldone
@rafaelgenel3 жыл бұрын
Do you know what is it’s operating frequency in Hz?
@yourheadlines30603 жыл бұрын
Good job. My question is, how do you test the ground and battery sides of the sensor wires from the ECU?
@MayoCarsDR3 жыл бұрын
Thanks for coments, and sorry for late reply,I use repair manual Wiring diagram
@lifeisbutifull20934 жыл бұрын
Good job
@NineUno62 жыл бұрын
What's the part # ? And I was wondering are there more than 1 valves to replace?
@juanmiranda45213 жыл бұрын
Question, is normal my oil control valve has continuity ?
@izanami63453 жыл бұрын
Thanks 👍
@shanimehar5552 жыл бұрын
Good work
@rickmathieu49002 жыл бұрын
So, if I test it and it comes back at 8.3 (which is obviously above 7.9) does that mean it needs to be replaced? Just didn't know if that is high enough to make a difference.
@MayoCarsDR2 жыл бұрын
Thanks for comment,If you checked it in cool condition and it turned out to be 8.3, I would like to change it.
@hasanhabeeb70532 жыл бұрын
Thanks for your help do this
@MayoCarsDR2 жыл бұрын
Thanks for comment
@tenmessaoud9426 Жыл бұрын
Thanks for the simple explanation
@MayoCarsDR Жыл бұрын
Thanks for comment
@tenmessaoud9426 Жыл бұрын
@@MayoCarsDR I want to ask you what is the function of this sensor, please
@AdnanAli-ts2gt4 жыл бұрын
Nice
@nonsoezeanubekwe4580 Жыл бұрын
Thanks for the video. Please, my mechanic used 20w50 oil instead of 5w30 in my 2005 Toyota Camry. In my next servicing, is it healthy to correct the oil?
@MayoCarsDR Жыл бұрын
Camry 2AZ 2.4L Engine oil 20w50 Camry 2AR 2.5L Engine Oil 5w30 Is ok
@axlemil2 жыл бұрын
Thanks for sharing
@MayoCarsDR2 жыл бұрын
You welcome sir
@abuhamidan34882 жыл бұрын
I found that OCV is 9.3 ohm, is it still ok or should be replaced by the new one?
@luispozo1869 Жыл бұрын
Did you replaced it?
@obnpchat3 жыл бұрын
I have Toyota Corolla 121 car and check engine light indicated on the dash board. After the scan it shows VVT-i sensor not working and I replaced it. Still the check engine light is ON and after scan it indicates the VVT-i sensor. But the sensor is working. Do you know any reason for this?
@iqrashah53683 жыл бұрын
there r two sensor in some cars 1st find and shear code which one sensor problem is it
@jeffautor93602 жыл бұрын
Hi good day..when i connect it with the battery..its opening and closing..but when tested thru multimeter..its only showing 0.01 ohms..does it need to be replaced?
@MayoCarsDR2 жыл бұрын
Yes
@haidymorine30244 жыл бұрын
Where can i find the filter of vvti solenoid in my camry 07?
I got camry 2007 and the rpm at idle is 890-915rpm,is it possible that the vvti is dirty?according to the manual it should be 715rpm at idle,
@MayoCarsDR4 жыл бұрын
Henerson Ursua Have you cleaned the VVTI valve filter
@haidymorine30244 жыл бұрын
Not yet,is it posible that dirty vvti filter is the prblem?
@kneebarx2 жыл бұрын
whoa mines i cant even budge with a screwdriver
@jeffautor93602 жыл бұрын
If this is bad..does it cause crank and no start issue?
@MayoCarsDR2 жыл бұрын
What happens when a VVT solenoid fails? A malfunctioning VVT solenoid can prevent the valve timing from advancing or retarding as needed. As a result, the engine may exhibit performance problems, such as rough running and poor acceleration
@yodaeee Жыл бұрын
@@MayoCarsDR does faulty vvti sensor correlate with bad fuel consumption?
@AnythingEverythingGh9 ай бұрын
@@yodaeee bad performance and poor engine running will translate to bad fuel economy
@ahmeddahmani42888 ай бұрын
👏👏🤩👉👍👍👍🙏
@hmroa30562 жыл бұрын
Your viewers need to hear what you are doing, as well as your demo. Your message is obscured with the color of the font and....STOP the music.
@MayoCarsDR2 жыл бұрын
Thanks for comment
@mooses62 жыл бұрын
@@MayoCarsDR 110% agree. The music of this video is completely unnecessary whereas the clicking open and closed of the solenoid during testing would've been perfectly fitting "music" noise and also informational. The Font color you've used for displaying informational text that narrates and educates throughout this video is hard to read. That makes the content lose significance or possibly be missed entirely due to the hard to read color contrasts which occur from poor consideration for selecting the color of the text. Why not simply narrate the words you are making appear in the screen?! The combination of text supporting/matching the words spoken would be helpful for anyone/everyone to figure out what is going on in the video and to ensure all of your points are clearly relayed and thereby understood by use of a legible font with a highly visible color. Speak! Turn OFF the Piano horror track musical selection you've forced upon this video.