How to: Use a High Precision Fiber Cleaver

Рет қаралды 34,896

3 жыл бұрын

A fusion splice or mechanical splice is only ever as good as its cleave. Improper cleaving, a dirty cleaver, or a dull cleaver blade can result in cracking or chipping in the fiber endface. It's also always important to clean BEFORE you cleave. Nothing should touch the end of your fiber once it is cleaned. After cleaving, the fiber should go directly into the fusion splicer fiber holder clamp or into the mechanical splice.
For more information on our Remote Certification Training (RCT) program visit: thefiberschool....

Пікірлер: 19

@girlmastergeneral 2 ай бұрын

Straight and to the point! Awesome demonstration! Thanks!

@jeffteng2343 2 жыл бұрын

This is very clear instruction to show how and how long doing the fiber cleaver

@TheFiberSchool 2 жыл бұрын

Thank you, much appreciated!

@ranamuzammilhussain2651 2 жыл бұрын

sir your video is very very halp full thank you sir

@muhamadhamizan2405 Жыл бұрын

How we fix the angle of cleaver?

@eliasbats9143 2 жыл бұрын

nice video and nice cleaver... where do I get one of these? Also, why are you collecting fiber scrap?

@TheFiberSchool 2 жыл бұрын

The cleaver we are using is the PRO FS-C97 (fiberoptics.com/collections/fiber-optic-cleavers/products/fs-c97). We collect the scrap fiber in a container to avoid anyone getting injured from loose shards. A lot of techs just throw them in the trash or on the ground. Those little glass ends can get stuck in your finger (ouch fiber splinter!) and we don't want glass getting into anyone's eyes either.

@asvarien 10 ай бұрын

@@TheFiberSchool You don't want to breathe a piece of glass either!

@umerniazi102 11 ай бұрын

❤

@weirdsciencetv4999 Жыл бұрын

How does one cleave plastic optical fibers?

@KallePihlajasaari Жыл бұрын

Sharp blade. Then some connector you melt the end into the countersunk end hole and in other connectors you crimp and then polish the end flat with a number of grits in sequence. Some examples on YT if you use the search term "terminating plastic fibre"

@QBlackDeathQ 2 жыл бұрын

Which fiber cleaver are you using?

@TheFiberSchool 2 жыл бұрын

PRO FS-C97: fiberoptics.com/collections/fiber-optic-cleavers/products/fs-c97

@palanipalani3362 2 жыл бұрын

Sema

@celticdabs6428 5 ай бұрын

Uhm, question..... Why are you cleaning THEN cleaving??? You should be cleaving THEN cleaning

@nohaynoticias 6 ай бұрын

EVERY SINGLE TRAINING VIDEO FORGETS BASIC INFOMATION: HOW LONG ARE EACH CUT. They say "its simple, remove the jacket..." HOW MANY CENTIMETERS, DAMN IT. Then you expose the bare fiber.... AGAIN, HOW MANY CENTIMETERS... MEASUREMENTS FOR HEAVEN'S SAKE!! Don't you have a ruler nearby???

@tylersmith9868 6 ай бұрын

Shutup