*Related Article* | joulemine.com/how-to-plug-into-shore-power/ Need your own Victron Touch screen? invertersrus.com/victron-touch-50-bpp900455050/?ref=JouleMine Need your own Cerbo GX? invertersrus.com/victron-cerbo-gx-bpp900450100/?ref=JouleMine

Thank you for this great break down! I’ll be watching this a few times to make sure I’m squared away. This is helping me to understand my Digital Multi Controller as well. I went with this “entry level” inverter control when I was building out my lithium system. That and the info from my BMV-712 Smart Battery Monitor allows me to get most of the info listed here. I do pine for the easy info shown on your Cerbo GX however. Maybe one day I’ll upgrade to that when I add my solar. Again, thanks for your production here.

Yay, you’re back! I was telling my husband you had the best solar installation videos out there. Glad to see the new stuff you have going.

This was so helpful! You are a great instructor.

Great advise! I usually don't change this setting. I think this explains why my generator no longer starts my AC unit. I will give this a try when our camper comes out of storage. Welcome back. The new name is brilliant!

Glad to see that you're getting back to solar and RV electrical content. Your How-to videos were/are one of the best resources for that info on KZfaq!

Subscribing from Facebook! Great job on the video ! I currently have been using Renogy products but someday I might play around with the Rona. It looks interesting.

Dude! You might have just save my camping trip! Thank you. I had a question, how do I get the setting for AC Current Limit and AC mode on the main screen? I had to go into the Menu to change my settings.

So awesome to see you and have met you at the Super Show

Thank you for your advise. I'd noticed that my inverter was always humming away whether I was plugged into shore power or not and now I know why. Switched to charger now while plugged into 50amp shore power. Did it cause any wear on our Multiplus II to have it always inverting for a couple years?

Here’s a general question that I can manage, but it seems like there must be an easier way… With the Victron Multiplus II, with 1000W of solar and 700Ah of lithium, I occasionally want the Multiplus to pass along the shore power (either generator or a household 15A connection) without it trying to also charge the batteries. Either I don’t want the generator running super high RPMs or blow a household breaker… What is the easiest way to tell it to pass the power through, but don’t charge the batteries (for now). What I’ve done is have to go through VE Configure and upload a profile that has the charging current set to zero. Is there a way to do this from the touch screen?

Hey you are back!