How To Use Momcozy M5: Complete Guide including Assembly and Tips

Рет қаралды 81,629

Күн бұрын

If you’re new to the Momcozy M5, then this how to use Momcozy M5 guide is for you!
In this video I am going to walk you through every step of using the Momcozy M5, from the different parts to assembly to the controls, so you can use your M5 pump with confidence.
GET 15% OFF MOMCOZY BY USING THE CODE: PUMPINGMILK
momcozy.com/products/all-in-o...
Whether you’re new to Momcozy wearable breast pumps or a long-time user that is looking to improve your pumping experience with tips and tricks, this guide on how to use Momcozy wearable pump is your key to unlocking a stress-free and successful pumping experience with the Momcozy M5.
✨D I S C O U N T S ✨
Check out my exclusive pump discounts here:
➡️ pumpingmilk.com/discounts/
FTC: I receive a small commission from the product links above. I appreciate your support! This is not a sponsored video. All opinions are my own.
#Momcozym5 #momcozym5 #BreastPumpReview #MomcozyReview #momcozy

Пікірлер: 70

@pumpingmilk 8 ай бұрын

If needed, you can buy additional flange insert sizes via Momcozy on Amazon: amzn.to/46sEw40 (affiliate). They have size 15mm, 17mm, 19mm, 21mm, 24mm, 27mm available. These will insert into the 24mm flange, so you only need the insert in the correct size and that will fit into the flange.

@ammarinayat 6 ай бұрын

Thank you for this video. The M5s instructions were not clear. Your explanation helped clarify. ❤️🙏🏽.

@pumpingmilk 6 ай бұрын

Thanks so much for the kind words! So glad I could help 😊💕

@ShortySensei 3 ай бұрын

I couldn't agree more! The instructions it came with were pretty bad! 😅 This makes it much more simple.

@bullshitOdonald Ай бұрын

Omgosh I didn't know you had to slide the lip of the diaphragm OVER that piece or that you had to stack the flange inserts! I think my experience is about to be enhanced just with these two changes!! Thank you so much for this video!!

@pumpingmilk Ай бұрын

So glad it was helpful!! I do have to apologize though, you actually do not need to stack the inserts for the M5 like I said in the video! Simply use the 1 flange insert with the correct size you need. But yes you definitely want the lip of the diaphragm to slide over as that will help ensure your suction is working properly :)

@natzcandy 7 ай бұрын

Thank you so much for this video you were so helpful! I am due this week with our 2nd and have purchased the m5 and cannot wait to try it ♡

@pumpingmilk 7 ай бұрын

Thank you so much for the lovely words! So glad I could help 💖 And I wish you all the best with your beautiful new arrival!

@Loralockz1 27 күн бұрын

Omg.. I had not been overlapping the flanges 🙈 No wonder I wasn’t getting a lot of milk! Thank you so much!

@pumpingmilk 27 күн бұрын

I am so sorry for the misinformation, but you do not need to stack the flange inserts for the M5. Just pick the correct size and insert that into the flange 😊 If you weren't getting a lot of milk, just make sure your parts don't need replacing and that the seals are all firm.

@frootluvr 9 ай бұрын

Great video!! I just got mine delivered today

@pumpingmilk 9 ай бұрын

That's exciting - Happy pumping!!

@RunnersRockguam 2 ай бұрын

This was great, thank you!

@pumpingmilk 2 ай бұрын

Thanks so much for the lovely feedback ❤

@jennawilliams3564 8 ай бұрын

Thank you so much for this video!

@pumpingmilk 8 ай бұрын

Thanks for the love ❤

@rosanamartinezfernandez2513 4 ай бұрын

THANK U. SO USEFUL!!! 😊❤

@pumpingmilk 4 ай бұрын

Thanks for the kind words 🙏 So glad I could help!

@user-xj3us7nh2c 9 ай бұрын

Thank you so much its a really helpful video ❤❤❤

@pumpingmilk 9 ай бұрын

So glad I could help! Thanks for the love - I appreciate it!❤

@marian2516 2 ай бұрын

Thank you so much!❤

@pumpingmilk 2 ай бұрын

❤❤❤

@elaafghamri2227 9 ай бұрын

Thank you so much for the informative video! Just a question, the guide says charge it before the first time use, and when I did, the charging dots looked solid! I’m confused does this mean it’s fully charged??

@pumpingmilk 9 ай бұрын

Thanks for your question! Yes when you have the 3 solid lines that means it is fully charged 😊 If it is still charging whilst plugged in they will light up one by one.

@khloeghazi4429 5 ай бұрын

Thank you for sharing 😊

@pumpingmilk 5 ай бұрын

❤

@A.TAYLOR 2 ай бұрын

Pregnant with my first and I’ve been looking at getting this pump! Thanks for this video! 💕

@pumpingmilk 2 ай бұрын

Firstly congratulations! And so glad the video helped with your decision process :) If you use my affiliate code PUMPINGMILK on the Momcozy website you'll also get 15% off if that helps (#ad)

@A.TAYLOR Ай бұрын

@@pumpingmilkThank you so much I will use the code! This was helpful to see how to use it. 💕💕💕💕

@pumpingmilk Ай бұрын

Thanks so much 💖 I hope it all goes amazing for you!

@fatimarashedabdulrahmanalm5271 5 ай бұрын

Thank u ❤

@maricarpenter5561 9 ай бұрын

Thank you for the very informative video! Just to clarify, we need to stack the different size flanges until we get to our correct size or do we simply insert our correct size into the breast shield?

@pumpingmilk 9 ай бұрын

Thanks so much for the question! And so sorry for the confusion, this was my error, if you are using the Momcozy M5 flange inserts you do NOT need to stack them, simply choose the correct flange insert size and insert that into the breast shield.

@maricarpenter5561 9 ай бұрын

Thank you so much!

@user-co4ev8mw9z 9 ай бұрын

Great video, I’ve just purchased this - do you know if I can pump after 18 months of breastfeeding (I’ve never pumped before)? Or have I left it too late. Thanks

@pumpingmilk 9 ай бұрын

Thanks for the great question! You can pump at any time during your breastfeeding journey 😊

@roroabdulla7027 Ай бұрын

I would like to ask while it is working is there any noticeable sound? I will use it during work

@pumpingmilk Ай бұрын

The noise is less than 50dB. A library or very quiet office is 40 to 45dB. Normal conversation is 60dB. So, depending on how quiet your workplace is, you may or may not notice it.

@user-pf7on8yq3p Ай бұрын

Does the inserts that you showed in your video comes with it?

@pumpingmilk Ай бұрын

Yes, my kit came with the inserts 😊 Just as a note in the video, I said you need to stack your inserts, but you can actually just use the 1 insert with your correct size. No need to stack them.

@mariaparsheva2857 Ай бұрын

Hi such a great video so helpful! FTM here...Can I sanitize all components by running it through my dish washer sanitation setting or should i sanitize by boiling the components.

@pumpingmilk Ай бұрын

Thanks for the great feedback! The M5 is not suitable for a dishwasher, microwave or heat sterilizer due to the soft silicone. Ideally you will boil it or use a sterilization solution like Milton amzn.to/3KTTNT0 (#ad)

@mariaparsheva2857 Ай бұрын

@@pumpingmilk thanks so much!

@wendytriumph9995 9 ай бұрын

Thank you so much! This video was real helpful. Blessings

@pumpingmilk 9 ай бұрын

Thanks so much for the lovely feedback 💖 So glad it was helpful!

@DaneldaMare 2 ай бұрын

Hi there, more or less how many 15min pump session will the battery life hold?

@pumpingmilk 2 ай бұрын

The battery life is 100-120mins, which is 6 to 8 15min pumping sessions. Hope that helps 😊

@rawanaldarwish5120 3 ай бұрын

So if my flange size is 17 mm, do i have to insert the 21 and top of it the 19 and on top of it the 17 ??? If someone can answer me , because this Looks confusing

@pumpingmilk 3 ай бұрын

Sorry that was my error in this video. You do not need to stack the flange inserts with the M5. Simply use the 1 flange insert with the correct size you need.

@rawanaldarwish5120 3 ай бұрын

@@pumpingmilk thanks for replying 🩷🩷

@julieleal1346 Ай бұрын

I bought my M5 in February 2024 and mine has a timer. I just pushed the little recycle button one time after the screen goes dark and then it shows how many minutes I’ve been pumping.

@pumpingmilk Ай бұрын

Thanks so much for letting us know! That is great news if they have included it in the newer M5 pumps 😊 I did double check mine, just in case I missed it, but there is definitely no timer for my M5 pump.

@maddygarcia5966 7 ай бұрын

You’re supposed to stack the flanges? I’m at 19mm

@pumpingmilk 7 ай бұрын

Sorry that was my error in the video! No you just need to have the 19mm insert that is compatible and that is placed securely into the flange.

@geestee9377 11 күн бұрын

The duck bill valve confuses me though. How are you supposed to fill the cup with milk if the only hole is covered?

@pumpingmilk 11 күн бұрын

Thanks for asking! The duckbill valve opens and closes with the suction created by the pump. So it will will open to allow the milk to flow through into the collection cup. If you pinch it the duckbill valve you can see it opens at the bottom :)

@CarrieannStirton 3 ай бұрын

My daughter has bought these . Does anyone know if you can mix between breast milk and formula from birth.?

@pumpingmilk 3 ай бұрын

It's possible, but I highly recommend that your daughter speak with their health care professional and lactation consultant for specific advice.

@elainewitman4041 Ай бұрын

Bwhahaha!! I thought the flanges went inside. No wonder i was leaking😂😂 ill try again tomorrow 😂😂

@pumpingmilk Ай бұрын

Hopefully, this does the trick for you! Just a note, I know I mentioned in the video to stack the flange inserts. You can actually just choose your correct size and use just the 1 flange insert 😊

@chloeneal3359 7 ай бұрын

How long would I stimulate before expression?

@pumpingmilk 7 ай бұрын

Thanks for the question! Around 2 minutes 😊

@maggiesapozhnik1696 7 ай бұрын

How can you tell it’s on correctly, as it’s impossible to see if your nipple is aligned down the middle of the flange

@pumpingmilk 7 ай бұрын

Thanks for asking! There are a few ways to know your pump in on properly and the flange is the correct fit other than just a visual.These include: You're not experiencing pain in your nipple or discolloration (i.e. a white circle at the base of the nipple or your nipple blanched). You can also feel to make sure that there are no areas of the breast that still have milk inside (which indicates the uneven removal of milk). Hopefully this helps 😊

@vukotaninkovic4328 5 ай бұрын

Hi My wife use it, but the milk go out just a little and we are so disappointed. Can you tell us a secret please?? ❤

@pumpingmilk 5 ай бұрын

Thanks for reaching out! Sorry you're having issues. My first step is to check all the seals and make sure it is assembled correctly. After that, start with your massage mode for 2 mins to initiate your letdown, then switch modes to your expression. Start on a low suction level and then slowly build up based on your comfort levels. The highest suction might not give you the best results. You may have to play around with the different settings to find what works best. Also make sure you are drinking plenty of water to help with milk production.