Nice job! Just a quick question. The brackets on the side of the table. Are those MFT mounts for the saw track?

Well done. I appreciate the detail of your work. Don't let the small minded get to you. A picture is worth a thousand words, spoken or not.

Nice table Mr! I noticed at 3:42 into your video you made the same mistake I've made. Directly after drilling the hole through both rules the top rule should've been moved then the pin installed to drill remaining holes. Reason being the pins only have enough shoulder to protrude through one rule. I had noticed this after making my first 90° so when i checked it was nearly impossible to get the pins through on the 9th hole because it had shifted ever so slightly. Luckily its only one roll that i caught before continuing. Perhaps it may never be noticed but when you turn the rule to the straight line of holes the pins are much easier installed and removed.

Looks great in black. Will finish mine tomorrow.

Great walkthrough James!

Great video and the bench looks great 🔥 🤙

Had my set for 3 years and still not gotten round to making my bench, and on that thought do u have a build vid of urs it looks amazing tbh Valchromat , got to love it haha, although thay the main reason i haven't built mine yet , i have 2 sheets of Birch Ply but no ruddy Valchromat for the top and wasnt paying what they've been asking for over the last 12months or , more hopefully it will drop a bit in the next few months 😂👍

Nice! Now can you repeat that again?

This would have been much better with audio

It looks like the sound is no longer available

what is your supplier for the black MDF??

I appreciate the fact that you produced this video to help people but without audio I find it very difficult to glean any information from what you're showing. While I'm trying to read your text I'm not watching the video. I'm a slow reader and trying to stay up with the text and the video is impossible and I would venture a guess and say there is a lot more people just like me that got frustrated and clicked off before they ever were able to finish the video please add audio to all of your videos so I we all can enjoy them. I am sure there are some folks that cannot read at all and depend on audio for information.

Это мдф?

You made the video without the annoying music. Good. No voiceover is staggeringly bad tho. We move on.

Why do you need so many precise dog holes in over 45 years woodworking i have never needed all you need is random holes and holdfast don’t waste time and money a solid bench and good vice anytime

Аргазм для глаз. Браво)

Come on man, what kind of KZfaq video is this? Where is all the ridiculous screaming over obnoxious music?

Should be titled how to build a PARF guide system…….. because you definitely didn’t show how to use it

Sorry, u made a mistake. Do not measure against the edge of the ruler, align the ruler to the line you made. Peter Parfit, the creator of the jig, told so in his video about. The holes in the ruler must not be in the midddle of, or straight to the ruler. Nevertheless, the holes are perfekt square, but it is not guranteed that they are suare to the edge of your tabletop the way you did it. I made the same mistake first time i used the jig... and wondered why my cut were not suare to the tabletop. Gladly i could cut the top a little bit, so trat everytyhing fits now. Took me long time to figure out why it was not square.