Thank you so much for this video. I’m doing a 4L65e to 4L80E swap in my truck. I’ve searched all over the internet on how to wire this switch up and you given me all the info I need. Again, thank you and you have a new subscriber.

good information helped me here in australia

Great video thanks for doing the hard work for us

Thank you for your video!!!

Thank you sir for this awesome video! I got a 2006 chevy suburban LTZ with the 6.0/4L60E. My (Drone mobile) remote start failed. Physically using ignition key... failed, no start. Come to find my starter froze up/ broke. I replaced starter... no start (no click, no low battery click). I charged battery, nothing. Verified terminals clean and tight. I checked fuses... main ignition (rectangle, clear top) fuse, burnt up. Replaced it... no start. I replaced ignition switch, no start. I replaced the 3 relays in main fuse box... no start. I replaced main power cable to starter, no start. I drank some water, scratched my head... no start. Slept on it... no start. Took it to the installer who installed remote starter (he the one that found the weird fuse blown) now there is power, but no start. So now literally.... thanks to your video, I will be replacing the neutral safety switch and be checking the condition of the solenoid wire. I can't think of anything else that could be bad. Ideas? Comments? Suggestions? Again thank you.

Thanks man....just what i needed

nice work 👍

Thanks big brother

Draw a little diagram, nothing fancy, of the wires from the pins on the switch to the starter etc. . .. where the pink and green wires go? What pins? What about the starter relay? Draw a picture of it and then film the picture. Thanks big man, a nice work.

SWEET!! I was happy just to know that the gear selector PARK postition is always FORWARD. My problem is there is some kind of gel inside the male terminals and I can't get the 2 connectors to snap in place. Amyone have any ideas???

Thanks for the video, I am assuming the switch will show all positions? PND321 ?

Ok so how do you find the wire that tells transmission to shift

Very helpful Thank you my friend

Hey I did a 80e swap on 03 tahoe would this apply? Truck indicated in 2nd causing no start but in park I jump green wire from sns truck started

Where did you connect the orange wire form the psi harness ?

I just put in a used 4l60e transfered my original switch didn't align it because I didn't know that they have to be aligned it only bolts on one way and the gear arm only goes one way back and fourth... My truck is jacked up in the rear and when I put it in reverse it last 3 seconds tires spin then stop .. new fluid new filter.. I was told that these switches nothing to do with how the transmission actually goes into gear.. but clearly it must ?? So my faulty or unaligned shifter switch could be the cause why my transmission won't go into gear because it's not getting ground or bad connection?? Weird how this lil peace plays a huge delicate roll.

the purple wire comes from the ignition underneath the dash inside cab?

Nice Video. #STAYSAFE #PHILLYPHILLY 🇺🇸

How does this method work for the single plug 2005 4l80e neutral safety switch

How about the reverse light?

I’m not getting no power in any wire

Actually lies it's supposed to be in neutral to remove it.. real transmission shops and ither KZfaq channels auto shops said so

MUCH NEEDED INFO BUT HARD TO WATCH A DIS-JOINTED NARRATIVE AND VIDEO!