HSRP (Hot Standby Router Protocol) Configuration In Packettracer

HSRP (Hot Standby Router Protocol) Configuration In Packettracer | Networking Academy |

Рет қаралды 5,644

Жыл бұрын

The Hot Standby Router Protocol (HSRP) is an IP routing redundancy protocol designed to allow for transparent failover at the first-hop IP router. HSRP provides high network availability, because it routes IP traffic from hosts on networks without relying on the availability of any single router.
Background Music Credits: Unknown - SergePavkinMusic
#Networking #NetworkAcademy #Academy #CCNA #CCNP #CCIE #Cisco #NetworkeNgineers #Ciscopackettracer #PacketTracer #CLICommands
#Basiccommands #CiscoIOSCommands #DHCP #DHCPConfiguration #Packetrtracer #CiscoRouter #CiscoServer #PacketTracer #CCNA #CCNP #Ciscocommands #Network #Codings #hsrp #vrrp #hotstandby

Пікірлер: 18

@NetworkingAcademy1 Жыл бұрын

If you have successfully configured the HSRP protocol, Mention it in the comment section. Thank you NA Family ❤❤❤

@veeramanithirumalarao1339 Ай бұрын

Supper video thank you

@NetworkingAcademy1 Ай бұрын

Welcome 😊

@mdjunaidgaming4590 5 ай бұрын

very nice explain

@NetworkingAcademy1 5 ай бұрын

Keep watching

@jabeerwrold768 Жыл бұрын

Thank you this video very helpful for me ☺️

@NetworkingAcademy1 Жыл бұрын

Glad it was helpful!

@modibo781 24 күн бұрын

Merci

@NetworkingAcademy1 23 күн бұрын

Heureux que cela vous ait aidé.

@arnaudentertainer Жыл бұрын

Wow it have been configured successfully Thank you!!!

@NetworkingAcademy1 Жыл бұрын

Glad it helped, Thank you for watching our contents

@arnaudentertainer Жыл бұрын

@@NetworkingAcademy1 You are welcome on: @arnaudtv1

@nissay4168 Жыл бұрын

This video cleared all my doubt, thanks NA.

@NetworkingAcademy1 Жыл бұрын

Glad it helped

@mautresim 4 ай бұрын

Thank you!

@NetworkingAcademy1 4 ай бұрын

Welcome

@vaibhavmorepatil2895 Жыл бұрын

What is the command for decrement priority value if destinations port was down state that's time for path change?

@NetworkingAcademy1 Жыл бұрын

If the primary router fails, the protocol will automatically connect to the router assigned the next-highest priority. ------------------------------------------------------------------------------ (Config)#Int Gig 0/0 (Config)#Standby 1 priority 120. Illustration for above configuration: (Config)#Standby ___ (any group number) | priority ____ (Value that you need to assign). ----------------------------------------------------------------------------- But i think to change path, you need to increase the next priority level for that path.