HT12E and HT12D the Encode and Decoder IC, Experiment Remote control

Рет қаралды 15,111

5 жыл бұрын

In this video, after you watch to the end, you could to designing a remote control project by yourself. The ht12e and ht12d is a pair of an encoder and a decoder IC. Many applications have used it. I hope you enjoy this video. If this is the first time for watching our video, don’t forget to subscribe to us.
#Encoder #Decoder #RemoteControl #wireless
Component ......................
433khz
s.click.aliexp...
........................................
24L01 , 2.4 GHZ
s.click.aliexp...
LoRa .
s.click.aliexp...

Пікірлер: 24

@pamieeberry9347 5 жыл бұрын

This video can help my project too much !

@sharmilatwayana5850 3 жыл бұрын

I was looking for this video.

@pinnie6647 5 жыл бұрын

That’s amazing 👍🏻

@deweywsu 3 ай бұрын

Great info, but where does one find non-counterfeit HT-12D/E today?

@bigbothoee8617 6 ай бұрын

Thanks man clear and straight to the point perfect but of extra info how secure is the encoder and decoder if I make a separate board will they interfere with each other ?

@MrProjectTSE 5 ай бұрын

If you want certainty and can develop it, 24L01 , 2.4 GHZ is recommended. s.click.aliexpress.com/e/_DmTxfOz And if you want a distance of kilometers, it is recommended to study LoRa . s.click.aliexpress.com/e/_DnSQMud

@planker 3 жыл бұрын

testing the 433 rx tx. some or the receivers require tuning. adjust the coil for best reception.

@euphoriachemistryclasses1383 2 жыл бұрын

I am using 1M resistor in Transmitter circuit and 33k reciever circuit in my RC car but circuit is not working motors are not rotating. I am using 433 Mhz FS1000a Tx and Rx module. Even the LED is not blinking on pressing any tactile switch. Can you help me.

@onlyme8477 2 жыл бұрын

The transmitter resistor and receiver resistor circuit must correct the value. This resistor for oscillator circuit if incorrect value circuit will not decode data or circuit will not work. I use 1 M for the transmitter circuit and 51k for the receiver circuit.

@euphoriachemistryclasses1383 2 жыл бұрын

@@onlyme8477 what will be value of transmitter and receiver resistor if I use 9 V.

@ReparodeDesktop 4 жыл бұрын

Muito bom, parabéns.

@manthan14190 3 жыл бұрын

it is momentary output , what if i need toggle or latched output. what changes i need to do ?

@ghulammohiodin1514 8 ай бұрын

Dear friend its old vedio. But maybe you help out. What is the sequance for password? If i am using 2 rf modules for diffrent project but in same place. Mean same house

@planker 3 жыл бұрын

thanks, i see my problem