Hub Bearing and Seal Replacement - Land Rover Defender, 1998 onwards (90/110)

No video

Hub Bearing and Seal Replacement - Land Rover Defender, 1998 onwards (90/110)

Рет қаралды 29,979

Күн бұрын

A walk through of the hub bearing and seal replacement on a Land Rover Defender, manufactured from 1998 onwards.
Although this tutorial video is specific to a 1998-on Defender, the principle is the same for many 4x4 vehicles.
In this we replace both bearings and the grease seal.
For a video showing the Front hub strip down go here: • Front Hub Strip Down, ...
For the video showing the rebuild, including measuring bearing load, drive shaft end float and brake bleeding (pipe and jar method) go here: • Front Hub Rebuild, Lan...
If you like what you see hit the like button, and if you would like to see more subscribe to Educational Mechanics here: www.youtube.co...
Visit our website for a larger collection at: edumech.co.uk
Remember - This video is a guide. Always refer to the relevant publications/workshop manuals
Camera gear used in this video:
Sony CX240 camcorder amzn.to/2yfEr7Q
Gopro Hero 4 Session: amzn.to/2geO1AK

Пікірлер: 11

@albertmusonda5882 5 жыл бұрын

Nice video sir but that's the wrong way to put grease

@matthewwalker5317 2 жыл бұрын

More grease!!!

@larsgreefhorst 2 жыл бұрын

Dude... The hitting it with a hammer and not even getting the force in the ring of the bearing is warping the bearing... If you want to do it like this, dont slip off with the punch.. Or take the old bearing and use this as an hammering template.. Cheers

@StrongManMattt 4 жыл бұрын

Pack your bearings full of grease folks, put a blob of grease in your hand and whack the wheel bearings side into it repeatedly...

@bigsky2063 6 жыл бұрын

Jesus Christ that’s NOT how you put grease on a new bearing! Fail!!

@craftykids7431 6 жыл бұрын

Why is it wrong?

@albertmusonda5882 5 жыл бұрын

Crafty Kids that's insufficient grease the bearings will run dry

@markian78 4 жыл бұрын

Crafty Kids you need to ‘pack’ the bearing with grease. Get a blob of grease in the palm of your hand and force the grease through the rollers side on, if you get what I mean. He’s probably replaced that bearing 3-4 times since the making of this video greasing it like that.

@cocoritemassiveify 8 жыл бұрын

Hi really nice video. how did you separate the wheel hub assembly from the disc assembly?

@EducationalMechanics 8 жыл бұрын

Thanks Romel. There is 5 bolts inside the disc that bolt to the disc to the rear of the hub. This picture shows the inside of the hub and the 5 bolts (12 point star heads.) forums.lr4x4.com/uploads/1204223413/gallery_2_473_27660.jpg Once the bolts have been removed, the disc and hub will separate with a little persuasion.