Hummer H3 front end repair

Рет қаралды 83,665

Robert Daigle

Күн бұрын

2006 Hummer H3 front end repair. Lower ball joint, tie-rod end and sway link replacement.

Пікірлер: 24

@peteriot15 9 жыл бұрын

Just so you know it makes it a lot easier to leave the tie rod connected to the knuckle when you're trying to break the nuts on the ball joints. Leave it for last. Good thinking on using the wrench as a spacer with the ball joint pickle fork :)

@2012Runnerboy 4 жыл бұрын

You guys did a great how to video Thank you

@israelcastillo1143 6 жыл бұрын

Excelente video, muy interesante!!!!!

@israelcastillo1143 6 жыл бұрын

Saludos desde Panamá

@wanabesurfer 10 жыл бұрын

Thanks Zach! Hope it helps!

@imtiyazkhan2921 5 жыл бұрын

Pyr

@richardmccarrell200 2 жыл бұрын

did the oem ball joint have a snap ring

@ZachMontizor 10 жыл бұрын

Great step by step video Thanks!!!!

@Chance21 7 жыл бұрын

That was a mevotech ball joint right? How long did it last for you? I just got one for my hummer and plan on installing today

@wanabesurfer 5 жыл бұрын

Chance Selvidge has the truck for 4 more years and still looked great.

@xacahaygun8590 8 жыл бұрын

super

@2wheelTyler 5 жыл бұрын

How did you remove the old one? Does that cap act like a c clip? Or does it just all press right out?

@MD-jp5oc 4 жыл бұрын

I think they just didn't show them putting on the new c-clip that came with the new ball joint.

@johnnywashington5889 2 жыл бұрын

You never showed how you pressed out the old ball joint.....?????

@jcreeker5581 Жыл бұрын

At 7:05 they talk about how they used the ball joint tool to press out the old ball joint. It would have been great if they would have shown how that was done though.

@libralongstroke 5 жыл бұрын

HOW DID YOU GET THE BALLJOINT OUT ?🤷🏾‍♂️

@wanabesurfer 5 жыл бұрын

LIBRA LONGSTROKE I used a ball joint separator and a open end wrench. Look at 2:58 in the video

@edsgarage001 3 жыл бұрын

Pretty sure he meant, how did you get it out of the lower control arm... Your video goes from it in there, to it out in a split second at the 6 and a half minute mark

@vloggershubby 8 жыл бұрын

here uae macenc I now hummer corvte Ferrari lombrghni rolce rice

@northernidahooutdoors3748 Жыл бұрын

Good video except you skipped over the lower ball joint removal process…

@wanabesurfer Жыл бұрын

I just rewatched that video 10yrs later and realized I left that out. Whoops. Honestly I can’t remember but I likely pressed it out with rental tool or put the nut on it and hammered it out with the sledgehammer. I think it was the latter since I was replacing the ball joint.

@northernidahooutdoors3748 Жыл бұрын

@@wanabesurfer same way I usually do them but was hoping you had an easier way lol.