Brother, I think you solved my problem. Hope to find out this weekend!

I needed a video to help me get those terminals out! Thank you!

Good job as always Sir

Great Video! Thank you!!! God Bless!!!

I think you're a magician. I bought a Husqvarna Briggs v-twin used. 180 hours. It ran and mowed a half hour, after I paid $800. I bought a new battery, key switch and solenoid but I found wires cut, that should have been to the lights. I found the conduit on the yard. It behaves dead like yours. It will crank if I short the solenoid terminals, but I don't want to ruin the new solenoid. I don't have a schematic to the yth2348 but I have to find out why the key is dead. The hour meter quit too. :)

Great video’s keep them coming thank you

TBone William I here. I think this is the video u we’re talking about on my issue with the pto not working

Thanks for your video. It seems like every electrical connection on these things is designed to fail. You pinpointed the problem I was having though. Thanks again.

Electrical can sometimes appear to be, and sometimes is a very daunting task. This was explained and repaired exceptionally well. Great job my friend!

Very helpful, thanks. No problem for me to see all you were showing

My hero, I think my harness is the problem. I had no idea how to check it. Thank you!

GOOD VIDEO THX Ed Loretto Ontario Canada

Good informative professional video. Thanks 😊tbone

It Worked for ME!!!

Its running so should be good to service and have it running great, fab vid

Awesome video brother. Thanks for sharing.

great job on that one, good explanation on installing those connectors.

Great job done again and well explained

Good find on the open circuit! BUT why in the world would you cut off a locking type & install a non-locker terminal? Just squeeze the female sides down on the OG & put it back in until it locks.

Very good 😊

Can’t emphasize this enough: The right tool for the right job. I learnt about U-channel crimpers about 30;years ago from the computer repair guy at work. Never had a crimp go bad since. I cringe watching folks use the crimper on a cheapo wire stripper multitool.

Great video brother

the best video

Good fix i use a stakon crimper.

Haistronica has ratchet crimpers that forms both crimps simultaneously for these open barrel terminal ends . Amazon $23.00

1:40 2:19 what I needed 3:08 3:33

I have a similar electrical issue. My Husky blows fuses as soon as you turn key on. I hooked up test light and determined it goes out of I disconnect the OTHER end of the harness. Using a jumper I can isolate the connection labled 2on the harness white wire goes up under the engine cover and then I have no idea :)

When I turn on the PTO switch I don't hear the click but if I try to leave the seat the mower shuts down as it should. Any idea why the blades are not turning. I checked the clutch wiring with the multimeter and the ohms are within range. It has a new belt. I did notice the lights no longer come on.

What does a19 set on a Bad boy set on? They have been set eveser 2019

I have a yth2348 it won't start I've changed the battery, ignition switch, Solenoid and still nothing im try what u showed any other ideas u can think of?? Thanks Michael

I have a 2019 TS142 and the fuse block is under right rear wheel well, behind wheel, directly under and to the right of the battery which is under seat. Manual says fuse block is behind dash...doh!...not always. I also had problems with ignition switch not turning all the way off so I had to replace switch as it was blowing fuse and stopping all power going to mower.

I have the same pair of crimpers from the same time from while working at the dealer

3:31 3:37 terminal removal

Great video sir! I enjoyed that explanation of the terminal failure. Can you tell me how to wire up the PTO switch for a YTH2148 Model?

Hey Raley .. just caught one of your Husqvarna videos .. no way in God's Green Earth I'll ever replicate your KZfaq instructions .. but now I'm a "converted Yankee" .. damn! You boys down South have their mechanical stuff together!! ..Meanwhile, I'll keep trying to fix this orange, Swedish, worm-smokin' , biscuit splittin', dung-flingin' lawn tractor ... somehow .. or not .. 2 yrs old, 18 hrs on the engine, new Die Hard battery .. and nothings happening

Thank you! So I have this same mower. My battery is fine but I dont have any power in my red wire to my ignition switch and the hour meter won't turn on either. No click when I try to start it but if I put juice to my solenoid, it turns over. Any suggestions??

Your test light looks like my old Matco one

Hello I wonder if you or anyone watching can help me with a problem I’m having , I have a Bolens riding mower and I put a new PTO cable on but I was still having the same problem, the PTO will only engage when the deck is in the highest position, does anyone know how the fix this problem, I’d deeply appreciate the help

From my understanding huskavarna and craftsman are very close to the same mowers eltrical wise my Craftsman had a burnt terminal on the key switch plug in

man you are one old dude hahaha thanks for the video

Have the same mower. Turn key and nothing. New battery and solenoid. Won’t even turn hour gauge on. Gauge does work, tried all part on other mower and it runs. Just not this one.

The only wire I’m having trouble with is the black one. My mower will be completely dead. I mess with the black one and it fires up. 🤦🏻‍♀️ Very frustrating.

Volume sucks can hear what you're saying