How is the generator going?

@@Nitroracer2332 really well, the fuel consumption is very economical.

@@tinkerbellfairylove hello, can I ask is the Genny still good….? I’m after one of these as they are so quite and powerful, is the Genny still reliable etc… many thanks

@@spice3767 it's still running perfectly, and fuel consumption is still very good, can't fault it at all.

@@tinkerbellfairylove brilliant thank you for the help 👍👍👏👏

exhaust extension is a night heater flexi pipe, I've put an ebay listing in one of the comments, the hyundai exhaust is 25mm, I had to enlarge the flexi exhaust ID with a mandrell, the spark arrester was left out, but I did use the end gauze because the exhaust sounded a little quieter. Not sure about earthing the unit, I treat it as a portable power supply, if you're concerned about the possibility of a faulty piece of equipment leaking voltage to it's exterior, I would use a plug in rcbo in conjuction with said piece of equipment.

Internal charger for battery, remote range around 20m uniterrupted line of sight

Still going strong, around 350hrs. Just required a new battery earlier this year

@@dangerrous That’s awesome, just picked up a used one tonight based mainly on your positive review. It didn’t come with instructions, do you know off hand the scroll order of the digital readout? It doesn’t mention it in the online manual I found.

@@AndyoLawrence Sorry can't remember scroll, but it's quite simple. fuel level in ltrs L output voltage, hr meter, approx runtime calculated against fuel level and Either amps or watts being drawn by equipment.

night heater flexible exhaust, make sure it's 25mm internal diameter, or use a mandrel to expand the pipe

This generator is still an important part of my van set up, The automatic choke can be a pan in the back when the engine is just warming up, sometimes I have to use the pull start to get it going again. The genny performs many tasks, transformer 110v powertools, phone charger, power tool cordless battery charger and finally clean 235v supply for mains and the inverter welder. The most I can draw from the genny for welding is 99amps, I can get away with most welding tasks, anything really heavy is served by our welder gennys or a mains power supply. We purchased this sinewave generator to perform many tasks, pricewise it's paid it's way many times over.

Night heater flexible exhaust pipe, just make sure to confirm the ID is 25.4mm, I had to enlarge to 1" from 24mm with a mandrell. The flexi pipe runs under the genny, I fitted the mesh on the end of the pipe, not sure if it really does anything. The genny has just hit 500hrs of use and is still going strong

@@dangerrous I’m glad you rate it

www.justgenerators.co.uk/generators/p1pe-p4000i-petrol-portable-inverter-generator.html

The generator is on a 'fitted platform' holding the the wheels and front feet in place, the strap then prevents it moving in transit. the exhaust pipe is from ebay, here's an example www.ebay.co.uk/itm/60cm-Exhaust-Pipe-24mm-Silencer-Muffler-Set-For-Car-Parking-Diesel-Air-Heater-UK/123941302971?hash=item1cdb7a32bb:g:4fwAAOSwb7ddFDCh you have to search for 25mm internal diameter pipe so it fits over the original exhaust. I wouldn't recommend fitting the genny in an unventilated area, the engine cooling fan moves a lot of hot air, my doors are open when running the generator. cheers Darren. Sorry no contact other than youtube

@@dangerrous thanks While gene is in the van, can I fuel it up ?

@@tcstigers I fill it up when still running, the top fill cap is surrounded by a rubber splash guard

@@dangerrous Thanks for the response. Does this take couple of attempts to start for you ? mine doesnt work as one touch in morning, it will run for few mins then go down (no loads on it, nothing plugged in !!) after doing this 3/4 times it will then run!! am i doing some thing obvious incorrect? Also it goes down after around 2 hours of running !! is it designed for that or thats the capacity ?

@@tcstigers Generator runs all day without fault. The electronic choke can be tempremental when warm, I have to start it manaully on the pull cord (about 6 good pulls). Check your oil level, if it is low the generator will stop, it takes about 525ml from empty. We run the generator all day with kangos and all types of 110v equipment through a commercial transformer, we have two of these generators on the fleet, both work without fault, apart from the electronic choke gremlin (this seems to affect all cheap chinese generators)

yep fine, over 700hrs

That's great news. Really want one but it would only be as a back up power source for my large koi pond... I'm assuming it would power a 10000ph pump and air pump surely? Also am I correct in assuming it's an inverter pure sine wave? I think you said it was but double checking. Lastly... how reliable is the remote start? I've heard it gives up after a few month Thanks again

@@Nitroracer2332 Pure sinewave, generator will output 3.5kw peaks at 3.8kw, no problems with remote start. I take care of the genrator, servicing every 100hrs with a filter clean and sparkplug change every 500hrs

@@dangerrous cheers I'll buy one

I use the genny for all tools 110&230v ac no problem. We run 9" grinders and kangosall the time cheers

They are incredibly quiet