Toni M the rails were supplied with the kit. These are designed for the IKEA wardrobes, I modified the cupboard opening so that I could fix the rails for the doors. I hope that helped.

Yes, I added a lip at the bottom of the cupboard opening for the bottom rail. The top rail was the same.

Hi, if you look around the 30 sec mark in the video you can see the rails are mounted inside the cupboard opening. I attached the bottom rail to a piece of timber that was the width of the cupboard opening. These rails came in the kit. Once the rails were in position, it was relatively straight forward to hang the doors. The tricky bit is to work out how high the piece of timber for the bottom rail. The doors are quite large, but the bottom part is off the ground. I hope this explanation helps.

Hi your video was very helpful and I would also like to do the same but was worried you had to have the PAX wardrobe system to fit the doors but is this not the case? Did you buy doors and fittings separately and customise inside?

Thank you for your kind comments. My Ceiling height is 2.429m. I will post another video as a follow up, I think it would be better if I explain it like that!

That's what I did. I had to make some rails to hang the doors.

@@SureshBopitiya I mean we have own old space. Not the one from ikea. Like we have brick work done

@@varshajuvekar8750 measure the space you have to make sure the doors will cover the gap and height. Then the next step is the make the wooden rails that the doors hang on. The inside or the cupboard is up to you. I hope this helps.