Incision Light Kit and AGFRC Servo Vanquish VS4-10 Phoenix RTR. They're super bright 🌞

No video

Incision Light Kit and AGFRC Servo Vanquish VS4-10 Phoenix RTR. They're super bright 🌞

Рет қаралды 3,013

Жыл бұрын

Going over the install of the Incision light kit for the Phoenix and touching on the AGFRC Servo.
Link to servo 👇👇👇👇
AGFRC 45KG Waterproof RC-Servo High-Torque - 12V Programmable Metal Gear Coreless Digital Smart Servo for 1/8 1/10 RC Car, Control Angle 180° (SA75CVSW V2) a.co/d/4YCWQmD
Link to light kit 👇👇👇👇
www.amainhobbies.com/incision...
#rchobby #rccrawler #tinytrucks #rc #smallyoutuber #vanquish #vanquishproducts #vs410 #Phoenix #ledlights #servo

Пікірлер: 10

@rcflashcars 8 ай бұрын

cool vid, my friend! appreciate the views number! keep it up! big like! 👍👍👍

@STP_RIDGELINE 10 ай бұрын

🔥🔥🔥🔥🔥🔥🔥🔥👍👊💯

@419crawlers 10 ай бұрын

Awesome video! I subbed look forward to the adventures ahead

@meanangel4life 10 ай бұрын

I have it plugged into channel 3 on the receiver but hitting channel 3 kn transmitter like you sed still doesn't turn the lights on and off. Is there a setting on the remote I need to activate in order to make it work?

@scalerockrc 10 ай бұрын

Shouldn't be, there's a switch on the light controller, you can use this light kit as constant on with direct to a battery or switched with the transmitter. It's a small switch, easily missed.

@meanangel4life 10 ай бұрын

Thank you!@@scalerockrc

@littleman350 8 ай бұрын

How did you set up the controller to turn off the lights? I haven't had much time yet to play around and try to get them to work but I am able to get them to turn on but have not gotten them to turn off yet. I am guessing something to do with end points but I had to stop last night and won't be able to mess with them again till probably tomorrow. I do have the switch put in the correct position but also plugged in the direct battery which may be an issue also even though they don't come on till I hit ch3 for them to come on just can't turn them off after they come on. I did set one end point at 100 and the other is still at 0.

@scalerockrc 8 ай бұрын

There's a little switch on the controller, out the box it's set to on. If you flip that switch it'll change to controlled on/off. I set mine to channel 3, so it's just on/off button. Channel 4 is my dig. I don't recall adjusting the end points for channel 3.

@littleman350 8 ай бұрын

@@scalerockrc Mine is on channel 3 and all I had to do was set the end points to 100. They now turn on and off. I couldn't find any actual instructions anywhere just played with things till they came on then did the same to make them go off just took a longer than I had the first night.

@Larki91 8 ай бұрын

uh um