You need to exclude the inner bearing for the first measurement so the clutch bell touches the clutch shoe, from here you can ad the bearing, shims and measure again to set the engagement gap.
@jessjess33692 жыл бұрын
Tuning caster/right height etc video?coming soon?
@wuchengchung7203Ай бұрын
It's a good video about Clutch installation, Thanks for sharing.
@thalesnunes33393 жыл бұрын
My car broke the second speed gear all the time, do you have some ideia how to solve this problem ?
@mattw6842 Жыл бұрын
Hello, I get revs, but the wheels won't spin any suggestions?
@kelbo1805 Жыл бұрын
Can anyone tell me where can I find the gears for this clutch
@nunoalvaroarcas49392 жыл бұрын
Do you still mount the pipe on the top deck? Or in the chasis?
@jillesgroskamp87522 жыл бұрын
I usually mount it onto my front bulkheads
@TATOLCM Жыл бұрын
Nice video. But as I understand, at the end the total gap is 0.7mm. I mean, the gap 0.5mm + the end play 0.2mm, am I right?
@jillesgroskamp8752 Жыл бұрын
Yes correct!
@TATOLCM Жыл бұрын
@@jillesgroskamp8752 Ok, Thank you very much Jilles. But isn´t it too much?, considering that you assume (you don´t meassure) the end play, you can finish with even more.
@jillesgroskamp8752 Жыл бұрын
@@TATOLCM my end play was about 0.2, it could be 0.3 so total gap could be 0.8. I usually do it like that and all my engine work fine with this clutch setting
@TATOLCM Жыл бұрын
@@jillesgroskamp8752 No dubt about it, thank you very much.