Never been this early and MY GOD these are completely insane! Will love to see these move and push some bass in a good box!

literally one of the nastiest sets of 10's out there!! good job

this reminds me when i had 6.5inch woofers that had magnets the same size as the basket :D

you can fit them into a 12 inch enclosure with a retrofit 10 inch face cut in half and screwed in place

Now this is what I'm really interested in I would like to see a video of you building another set hybrid subs

I'll bet the excursion doesn't change, no matter what enclosure they're loaded into. With that much force to overcome the stiffness of the suspension, and that small piston area, acoustic loading is almost irrelevant. These remind me of a bass version of horn drivers, designed for extremely high pressure, though with minimum displacement.

Reminds me of the DC level 5 10", monsters! Those would do great in a horn I bet with the low qts and high bl, would load them up real good too. Nice work!

build a t-line for those bad boys! meter them as well! interested in the numbers!👍🏼🔊🔊🔊🔊🔊🔊🔊🔊

Holy fuck you had to use a Crown 2k just to move them? INSANE! Very nice sir. Keep using that to break the spiders in

motor looks massive!! 😱😱

I miss not seeing new upload notifications, wherever you are; may you be blessed

inverted only's, LOVE IT

Those are some sick woofers man. good job.!

Maybe a 2 piece adapter ring? I don't know how you could mount them. Crazy drivers. Hope the baskets don't crack after mounted.

Sick!!!Wish I had just one 10 back in the mid 90s to bump everyone out!

Would be awesome to see and hear these on some real power and in a good box! I'm not 100% certain but I think Decaf Astra (one of the meanest audio installs in Finland) has the Banda 9k's just rebranded. You might want to check him out!

These behave a lot like the MTX RFL152, where the suspension is so stiff they cannot play music AT ALL. The RFL had six spiders, and were tuned to about 60 hertz (and that's pretty much what they were made to play - 60 hertz burp tones for SPL that's IT).

I think these could actually play fairly low in a vented box if the Qts were increased. Smaller magnets and a triple-stack would probably do it, because the bonding area of the magnet would be reduced. (Target Qts would be ~0.6.) A cool benefit to that approach is that the port is active over a wider frequency range; somehow, the woofers are able to drive the port up near their own resonant frequency, then below Fs (in a large enough box) the port becomes active at the box Fb, and this lets most of the air movement come by way of the port over a wide bandwidth, and you're really not restricted as much by the driver excursion limits.

damn you got skills

Crazy good work man

Get your hands on some Audiobahn Pro Pressure subwoofers from 2001. AW1008x AW1208x AW1508x. Massive motors with 4" coils. The magnets were about .5" less diameter than the basket.

How heavy are they ? Damn

I can tell those would sound great in a box and do some very low bass. Great job.

where are the continuation of dd9915 vs sundown with the box comparative??

Pretty soon it will be 4 inch subs with 10 inch coils

Lollypop tone was awsome

Beast of subs ! Great video

it's all about the box. also ground . an voltage.👌

Man you are crazy...these are monsters...

It looked small before u put your hand on it now it is huge!

wow wtf I thought my puch dvc's were beefy. This is military grade man!

Nice project but I would have went with 12 inch woofers.😊

I have Rockford hx2's actually just one 10" and I'm pretty sure it has a 4" voice coil. But those are amazing looking subs, sure would like to hear one in a box. Cheers!!

That red subwoofer was prolapsing!! Damn

Crown amps are amazing! I used to have a crown k2.

man those are beautiful

very nice build sir

The "SEVEN" 10" subwoofers have 3" coils...

you know that Rockford has been making 10" subs with 4" coils for years and years right? lol

bro are these subwoofers out of phase ?? 6:22

good job!sound great.

Wow i love it bro

I love my sub builder:)

beautiful I love 1 off things

Those are bad ass, how much power will you be running to the pair of them? And are those for sale?

Nice Build!

Bit of Ukg towards the end, nice

That is sick.

I wish I can get my hands on one of these basket

how do you mount them you would have to invert them.

Motors look similar to a mtx 9500 which also have a 4” coil

sam,,,,, you must have tiiiiiiny hands, as i have as a reference, found that my hand can just about reach/cover across a 10 inch sub, and they looked like 12/15s when u pushed the dustcap LOL :D

Is that much magnetic field really needed to fully saturate the poles? Why not use neo slugs to increase thermal efficiency in order to mitigate power compression? All that BL wasted on that cone area.

I can't get serious advice from a leprechaun

Except for the MAJOR audio distortion in the recording of these AND even VIDEO distortion, (probably due to the refresh rate of the KZfaq video or maybe my computer), making them look all "wavy" and shit, these look like some pretty awesome 10" woofers!!... I know they sound MUCH better in person too; the KZfaq video cannot even come CLOSE to doing them any justice sound wise!... Do you have those both wired in series, (2-ohm load), I guess, since your Crown Amp I'm sure isn't rated to safely handle 0.5-ohm loads?... And is that 2000 watts total, (1K to each woofer), that you say those amps are putting out, is that power rating into a 4-ohm load, or is that the power they put out at 2-ohm?... And also, do you have the amp running in parallel mono bridged mode, or are you running it stereo mode, with one channel powering each woofer, (in which case the amp would be driving a 1-ohm load per channel)... Just a "techie nerd" wondering about the details of your setup, LOL!... Pretty cool, no matter what!

grave cabuloso igual da minhas miniatura

I work in pro audio, why do we not use these type of drivers in PA cabinets?

Nice!

Those waves ! :D

Good shit Beast mode👌👌👌👍👍👍👍🔥

I wonder if you can use the high speed camera to see them out of phase

Looks like the Drivers are oversized for the fucking 10s like holly fuck xD

That's so totally Maddd

Those feckers need to be chained up!!!

Sold it cause of marriage, children and financial desperation. Still wish I had that k2.

What do you use to shim the coil during spider install?

yeah...i love it

looks like old soundstream xxx.

What's the bass track name you used...? Would love to hear it in mine...

eh....arent they impossible to install? because the magnet is bigger then the basket??

Hey Bare I have a question. Ive been wondering does under powering a sub hurt it? Noob question from a bit of a noob, sorry for the bother.

Wow that can.move

Amazing

can you even mount these? the magnets are the same size as the mounting ring.

what's the BL on these babies?

Dats wt I talking about wise I was there wen it goes in a box

OMG

Ceramic magnets is so 2008. LOL Get a Powersoft K20 amp hooked to the mains. Watch them jump like a starving pacman frog!

what is the point of having such large coils on such a small woffer? what does it get you? the subs only have so much vas so are we not just wasting power here?

wow i would love a set of these i need you to make me some 8 or 10in subs crazy like this

I want to know how you knew where to hang the coils .

4:16 whats the point of such a stiff suspension? Aren't you just wasting a heap of power working against the stiffness?

Ước gì mình cũng có được một cặp súp như thế này . Nhìn thấy thèm quá 👍👍👍👍👍

Are they moving in opposite directions

You can mount them in a box then close them in. Will you consider making me some 12s with these parameters? I can pay and i know its not cheap

2 tens or 2 Fifteens? which is preferred for more bass

MAAAAAAAD

Extra stiff means deeper bass once you get them moving.

I won't the 12s like that but a lil more crazy lol

will we ever see these in a box tho?

how much u want noting over priced plz but how much if your selling them

that wound work perfect in my car

Can anyone tell me what track that's used at 5:30 in the video....?

That is good for a 10"

I want some

Were could I get some of these

do you have a link to that music i have 2 pairs of old skool 12 inch tarantulas i would love to hear this

monster vibrator

question ?, they're beast but how can they be mounted other than inverted? the motor looks to be really wide

I think I would have been better a better set up if he used a 12 inch subs.