Watch the step by step process of this rubrail installation. Everything you need to know to do it yourself. We are using the new SuperFlex rubrail from Taco Marine. #diyboat #boatproject #tacomarine #boatrepair #boatmaintenance
Пікірлер: 42
@silverbull29322 жыл бұрын
Thank you for the video very helpful 👍
@CaptOrlandoMuniz2 жыл бұрын
👍👍👍
@webe_fishing93453 жыл бұрын
Came out awesome!
@CaptOrlandoMuniz3 жыл бұрын
Thanks Bud! 👍
@lesfaust96342 жыл бұрын
Looks awesome 👌
@CaptOrlandoMuniz2 жыл бұрын
Thanks! 👍
@radjifmaduro3661 Жыл бұрын
Nice looks easy enough. Black nail polish for that set screw, I would go bunkers seeing that SS screw peaking out like that. Nobody will notice but I would know🤣
@CaptOrlandoMuniz Жыл бұрын
😂
@TexasDeepSeaFishing3 жыл бұрын
was looking for your episode on how to rig for bottom fishing big fish.
@CaptOrlandoMuniz3 жыл бұрын
Here is the link. Let me know if you have any other questions. Tight Lines, Capt. O kzfaq.info/get/bejne/i9Zke9iitZvTn5s.html
@BattleshipGrafSpee2 жыл бұрын
Beau travail messieurs ! :)
@CaptOrlandoMuniz2 жыл бұрын
👍👍👍
@scottlomas91653 жыл бұрын
The cap on my boat in the bow appears to be coming loose from the hull after many years (1985), it looks like I'll have to remove the rub rail to reattach it, it appears also looking from inside the boat that rivets were used instead of screws. I noticed that my rub rail was sealed on both sides with silicone and in your video you didn't do that, any particular reason why you would or wouldn't do that?
@CaptOrlandoMuniz3 жыл бұрын
Silicone can be used, especially if there is a gap between the hull and the rub rail. In my case there was little to no gap. Hope this helps! Tight Lines, Capt. O
@jheiny1231 Жыл бұрын
Extra screws in the rub rail will hold the loose side of your hull down. And the seam between the cap and the hull you would want to caulk first before you install rub rail. You don't want to caulk on top and bottom of rub rail because if water gets in behind in needs a place to drain or you will have sitting water
@ShorrockPaul2 жыл бұрын
Nice install. , useful tips. Bit surprised no silicone on the new pan head screws ? is it not necessary ?
@CaptOrlandoMuniz2 жыл бұрын
Thanks! It can be used but not absolutely necessary. 👋👋
@johncarpenter14764 ай бұрын
Good video and tips, but I respectfully disagree regarding the silicon with screws. After time, those screws will develop small intrusions, develop enough cracks that its not IF, but when they start leaking into the interior. EVERY other video on this type of project includes cleaning the top/bottom boat joint new silicon on the joint AND silicon on the set screws to eliminate water intrusion... @@CaptOrlandoMuniz
@capt.orlandomuniz-espanol26804 ай бұрын
@@johncarpenter1476 👍
@user-mf2ru9bf4n2 ай бұрын
Should silicone be used on top and bottom of the trim?
@CaptOrlandoMuniz2 ай бұрын
Yessir!
@patrickhampton62483 ай бұрын
How to get someone to fix my rail replacement
@CaptOrlandoMuniz3 ай бұрын
There’s a guy in Miami that specializes on rub rails. Believe it’s called Tommy’s Rub Rail. If not a lot of boat shops do it too.
@cowboysnation1594Ай бұрын
Where do I buy this?
@CaptOrlandoMunizАй бұрын
tacomarine.com/rub-rail-kits?gad_source=1
@abelvazquez60122 жыл бұрын
That old rub-rail is 1-7/8 and that new Suproflex rub-rail is 2" inch, it comes out to flush at the top.
@CaptOrlandoMuniz2 жыл бұрын
💯
@goose311713 жыл бұрын
Hard to watch when the rub rails is getting stretched and dragged on hot cement. That’s a big non. Either do it over grass or lay down some blankets.
@CaptOrlandoMuniz3 жыл бұрын
💯. We used blankets as much as possible. 👍
@bipedalhominid68153 жыл бұрын
That rub rail you pulled off was horribly placed on the boat. Looked like a rollercoaster. Good job replacing it.
@CaptOrlandoMuniz3 жыл бұрын
Yes, It was badly damaged . Thanks, Capt. O 👍
@jasonmurray84667 ай бұрын
It's like a human pacifier/face diaper
@CaptOrlandoMuniz7 ай бұрын
💯 😂😂
@mikesanders9026 ай бұрын
Mask????
@CaptOrlandoMuniz6 ай бұрын
I’m not a fan of masks but this was done during Covid and there was a good reason. 😌
@ShadyOne9 Жыл бұрын
I cared up until I saw the masks…. 😂wtf are y’all doing? Lmao
@CaptOrlandoMuniz Жыл бұрын
Lol. I hate masks too!! 🤣 This was done during the height of the pandemic. Lol
@keepnitreel25823 ай бұрын
Looks great, is it recommended to put 5200 or are the screws enough to hold in place