Installing an hour meter on my new Eastonmade 22-28, and the first test run.

Рет қаралды 1,057

5 ай бұрын

On this episode, I will be installing a Chinesium hour meter onto my new Eastonmade 22-28 log splitter and then feeding it some rounds to do its first test run.

Пікірлер: 8

@kragonstone 4 ай бұрын

We picked up our 22-28 on 02/20/2024 and we are loving it! Eastonmade Road trip: kzfaq.info/get/bejne/b8mHpqifltiXY4k.html

@fabricating_firewood 4 ай бұрын

Very exciting. You’re going to be impressed with it! My 22-28 just pushes through everything.

@hayesrutherford9415 5 ай бұрын

Hope you get that speed figured out.

@fabricating_firewood 5 ай бұрын

I did. I just needed to reset/adjust the two stage pump set screw back to factory setting. You tighten it down, loosen it 2.5 turns and then set the jam nut again. It brought it back down to just over 7 seconds under no load in the first stage. I will be shooting a video on the adjustment and seeing if I can get it closer to 7 seconds exactly later on. Thanks for the comment.

@hayesrutherford9415 5 ай бұрын

Good to know. I may be getting mine as early as May.

@fabricating_firewood 5 ай бұрын

@@hayesrutherford9415 Yeah, I just saw a video from Eastonmade the other day that their lead times on log spitters is now down to about 3 months. That is fantastic. Mine was ordered in August of '23 and they said 12 to 16 months meaning I wouldn't possibly get my 22-28 until after August of '24. Then in November-December Andrew did a video stating that they were now at 6 months and I got mine delivered at the end of January. And I am here to tell you, there weren't any cut corners on this thing. It is quality built!

@joekrzeminski467 3 ай бұрын

That 22-28 is not running properly. I would call Andrew and ask him to review this video.

@fabricating_firewood 3 ай бұрын

I just needed to reset/adjust the two stage pump set screw back to factory setting. You tighten it down, loosen it 2.5 turns and then set the jam nut again. It brought it back down to just over 7 seconds under no load in the first stage. I will be shooting a video on the adjustment and seeing if I can get it closer to 7 seconds exactly later on. If you watch our first run video it’s at the 7 second cycle time now. Thanks for the comment.