Installing an Off Grid Aviation Throttle on a Paramotor

Рет қаралды 571

Cloud Walker PPG

Жыл бұрын

Installing an Off Grid Aviation Throttle on my Parajet Maverick Paramotor with a Moster 185cc motor

Пікірлер: 4

@tzgardner 11 ай бұрын

8:08 I noticed this connection was soldered to the tab on mine. I tried to work it off carefully and slowly but the tab on the Electronic Ignition Coil Selettra broke off. I ended up having to buy an new one which cost about $60. So, for future enthusiasts, just snip the wire. I wish the off-grid throttle would come with parts to couple the wires together instead of the female spade connector. Or maybe both.

@cloudwalkerppg504 11 ай бұрын

Yes, I felt the same way when pulling on the connector, that's why I gave up and just cut the wire. Did not want to damage the coil. Cheers

@Daviation1977 5 ай бұрын

Hi there. What length did you go for? 48"? I have the same Moster 185 rig but wasn't sure what length of throttle cable to go for.

@cloudwalkerppg504 5 ай бұрын

I just checked and measuring from where the wire comes out of the housing to the very end of the throttle handle is 44". I did not shorten the cable, that length is how it was manufactured. Also I have removed the attachment of the throttle cable to the swing arm. I let that part hang free, as I found it to be too restricting. With that said my Maverick does have a gap down low in the netting and was afraid that the throttle cable could get shoved through there and reach the prop (this happened to Judson Grahm in one of his videos where his throttle cable got trashed). So I made my own section of netting to close the gap. I have never had a problem since. Cheers