My old clust has 3 plugs at the back,and my new one has 4. Is there a diagram to rewire please.

@@ultrainstinct1181 sorry, i have no diagrams.. couldnt find them for my car either. Seems strange that the number of connectors is different, are you sure it fits your car?

@@pistamessi yeah,it does it's from the denso 2e to the denso 2 160i with Speedo.

I just found this and I have this problem. Could you clarify if I need to solder the two wires in the connector side? Brown from connector to yellow from the cable tail?

@@yomurita oh man, its been a while since i did this, but basically as far as i remember, i cut the brown (i believe the one next to the yellow-green) and soldered the brown from the connector to the yellow-green in the loom. Just took the isolation off the y-g and wrapped the brown around and soldered it. I believe the y-g is the wire that goes to the temp sensor so you have to connect the brown from the connector to it. To figure this out I followed the conductive trails from the clusters and compared them, so you can check it for yourself. Hope I helped with this. Tell me if it worked :)

actually I didnt miss a wire for the temp. the temp works fine at around 7:06 you'll see that the temp is in the middle like in normal state of temp :D

@@jayeconstantino Interesting! Temp didnt work for me and when checked negative ground is missing, perhaps a problem on the printed circuit. Point is such replacement works great and is very exciting to drive having tach on the dash. Regards from Cuba!

@@jorgeborroto5822 yes very true it's good having a tach. thanks man!

hi guys. i also have same ee90 panel gauge. I did diy change of panel gauge to led lights last week. now I have a problem on my gas and temp gauges. The gas gauge now goes to full as soon as I turn the key while my temp gauge no longer triggers the automatic switch on of my rad fan once temp gauge reaches the middle. It just continues to rise to overheat even if I already switched on the aircon with both rad and aux fans running. I believe this is not the correct reading since this only happened after I changed the gauge lights to led. I did not do anything else but change the led bulbs since I don’t know anything about electricals. Can you guys pls help me coz I can no longer drive my corolla sb since I’m afraid that I might overheat on the road although I know that the temp reading is not accurate. Thanks.

@@josephreyes9778 try to visit an electric shop near you bro! baka wiring problem lang or sensor ganun. hehe wala din me deep knowledge sa electrical e.

I'll give you the link regarding on how to check the rpm wire to manually link it kzfaq.info/get/bejne/oqeGmpyIl9aafqc.html

you need to locate the rpm wire and manual input it. maybe you don't have the original distributor that's why it's not automatically wired

I did swap it completely, I didnt bother to change my old odometer bec I am scared that it might not work If I change it to my old. Just swap it plug and play!

@@jayeconstantino Yeah true, in my country we have to show accurate odometer reading, hopefully i can swap without any troubles.

@@knibusu2249 let me know how did it went after you do it! :D

not quite sure about the diagram bec when I had it installed it has the same diagram maybe you have different model or it's not really plug and play try searching out "ae92 gauge berdie" he tried checking the diagram bec he didnt have the original distributor

Hi, regarding temp gauge, you just add a ground connection to the (-) point of the gauge and it will be fully functional.

it's plug and play if you have the original distributor of your car. but if the rpm didnt work then it means it's not the original distributor. but usually it's plug and play! thanks for visiting my channel man!

@@jayeconstantino great! distributor is original, only what i did on my car is solex 40 addhe carbs upgrade and I want to have rpm gauge, and car have only 75K km only

@@manojlo5946 wow that's so fresh! ^^

@@jayeconstantino Where did you buy laps for tachometer?

@@manojlo5946 what do you mean laps?

kay Jay Zam paps. madami nagbebenta online tingin tingin kalang :)

yes po t10 led nilagay ko hehe

actually natutunan ko kay brother breds and ez works garage kay doc chris na mas maganda full tank siya agad tapos if bumaba below half full tank na ulet hindi siya sayang mas maganda daw yun sa life ng makina and ng sasakyan mismo lately bro di ko lang vinideohan kase may mga ineedit at asikaso ako pero nangyari saken below half siya may isang guhit pa pero di na siya mag start upon checking gas lang problema di na umangat kaya ang ginagawa ko lagi kapag half na full tank na agad para monitor mo din kung ayos yung fuel gauge mo :) pero sa mga groups if ever palyado yan sa mga groups naten dito merong mga nag rerepair nyan! good day ka corolla!

@@jayeconstantino Maraming salamat boss. :D

where are you from brother? this is from the fb marketplace here in the Philippines.

@@jayeconstantino I am living in Turkey, if the cost is not too high, I can buy it. 1 US dollar is 8 Turkish Lira. Also I need shipping of course. 🥺

@@FatihCanVaral not sire how much shipping is there no corollas being part out in your area like surplus shop for parts?

@@jayeconstantino there are some shops but they want really high prices. If you have any link, I would like to discuss with seller.

wala paps kapag orig yung distributor plug and play pero kapag hindi na original distri watch mo dito yung babanggitin ni paps berdie kzfaq.info/get/bejne/oqeGmpyIl9aafqc.html

I do have the same issue that's why I always do full tank every after using :D

@@jayeconstantino and do you know, how i can fix that?

sadly I don't@@luislovell2000

di ko sure bro pwede mo naman try if ever di gumana yung rpm ibigsabihin di orig yung distributor if ever gumana edi goods haha

Upload po ako tomorrow ng mga pano kalasin paps may mga screw lang yan sa paligid then pagdating sa gauge is may reference galing kay sir berdie naman na corolla owner din kakatuwa dito sa youtube tulungan mga naka corolla may mga new things din akong natutunan from sir berdie and sir breds ❤️ mabuhay tayong mga naka corolla

actually nandyan pala sa video ko yung mga pwesto ng turnilyuhan na aalisin mo :D

@@jayeconstantino abangan ko bukas paps papasubscribe na rin kita sa mga kaibigan ko po 😊 TIA po😇

@@dodengdaga4138 nandyan paps andyan mga turnilyo na kailangan mo alisin watch mo hehe

sa marketplace po madami mam. check AE92.ph group or yung group ng friend ko which is Toyota Smallbody&Parts JDM/PHDM at iba pa(SeeJeem) check nyo lang madami nag bebenta nyan mam!

@@jayeconstantino okay po sir, salamat po,

meron sa marketplace brother

​@@jayeconstantino hirap humanap dito sa america ng may kasamang tachometer puro oem replacement lang

@@jojoordoveza6539 pasuyo sa uuwi na kamaganak hahaha mahal yan sa america for sure since onti lang pala puro oem replacement meron.

na totono yun malapit sa may carb hehe pa tono mo sa mekaniko mo then sunod nun ikaw na naglalaro ng rpm pero di okay yung 500 rpm lang ha stable rpm na ginawa ko is 800-900

t10 bro saka t4 ata yung isa

a tip: watch movies on Kaldrostream. I've been using them for watching loads of movies recently.

@Keagan Duncan yea, been watching on kaldroStream for since november myself :D

@Keagan Duncan Definitely, been using kaldrostream for years myself :D