I seen on Nate’s garage he cut and grounded out some space between each port on the header mount plate basically giving it a little flex for install . Im going to tackle this soon and do the same

i ordered ebay headers for my 01 330ci few years ago.. had my engine out anyways. threw them on, dropped the engine in and the last o2 bung is too long and wrong angle. swapped my factory ones back in, ebay headers still hanging out in the garage lol atleast till im commited to do a o2 and secondary air pump delete with the proper tune. anyways thanks good video, good info

Nice video, where I get headers like that for my bmw 325i 2004 4 doors e46, and what 02 I have to connect, the top or the bottom.

Hii Link tho Headers plz thx

keep it up!!! Car sounds great

Broo.. where can I score uel headers for my e46.. I need the subi.. sound

Did you have problems with the headers hitting the motor mount

About to start installing mine today hopefully it goes well about to cut the 02 sensors down on the headers,

Where you get the tie rods

Nice job papito. Im about to bring the old 93 SI Honda back lol.

Cat sounds great bro, these headers have been around a long time and have always been problematic. That rear section especially never lines up with the factory flanges. It's a tough job but you got through it💪

hey do you have a link for these headers very hard to find

Have you noticed any performance improvements since the install? Thanks for the great video btw