I installed SW Motech risers. It’s not very difficult to install them but I’ll try to do a tutorial on how to do it in the future. best regards!

I think there is a plug close to the 12v supply in which you can connect the oem heated grips.

If you fit the oe heated grips, they are controlled off the existing buttons. And they are that hot you can't leave them on high even in the snow.

Hi! I used the glue provided with the grips, which was a type of super glue. But you can use any sort of rubber/plastic/silicon glue as the grip fits tightly. best regard!

in my personal view , for the following reasons: Honda’s grips are unreasonably more expensive, Oxford is one of the best hotgrips manufacturers and you can use in other bikes if you change your AT. You can use for many years. Also, the wiring is the same

​@@MrLuk78the Honda grips make the Oxford ones look like rubbish in terms of heating ability. The Oxford ones have massive connecting wires that get in the way as well, especially off road. You should have bought the oem ones. Trying yo transfer heated grips between bikes is not usually successful as they melt ionto the bars after time and are almost impossible to remove.

Agora no verão todas esquentam muito. A minha XTzona pega fogo! O problema, ao que tenho notado, é o trânsito aqui de são paulo ,onde os corredores estão mais apertados e mais congestionados. Tudo piorou no período pre natal. Incomoda mas na minha visão não mais ou menos que a f850. A F800 era bem pior! Na estrada super tranquilo!

I installed the SW Motech risers. I’ll try to do a tutorial in the future but can assure you it’s quite straightforward. best regards